Manual Graupner MC 32 HOTT (page 14 of 345) (English)

467111

Zoom out

Zoom in

1/345

14 Remote control set description

• As many as four servos can be controlled simulta-

neously as a block in the SAME operating mode

with a servo cycle time of 10 ms (digital servos

only).

• Thanks to cycle time reduced down to as little as

10 ms, extremely short response times are achieved.

• Real-time telemetry evaluation in the transmitter

display Additionally, telemetry data can also be

selectively displayed by the SMART-BOX.

Additional HoTT features of the mc-32

• Super-fast response time through use of a fast

main processor for data transmission.

• Micro-SD card for storage of telemetry data and

for additional functions

• Obsolescence-proof through update capability over

USB interface as well as via the micro-SD card

• The included Lilo battery (changes reserved) has

a capacity of over 6000 mAh. This makes extreme-

ly long ﬂ ight times possible and also reduces the

number of charging repetitions.

• Modulation changeover per software: e. g. from

"EXT. PPM" (e. g. Weatronic) to HoTT at the press

of a button.

• Swashplate limiting: This function limits the

swashplate's tilt angle to prevent the potential for

mechanical collision in helicopter 3D operation at

full-limit roll and pitch-axis

• Ring-limiter: functions similar to swashplate limi-

tation but is used for control of up to three Voith-

Schneider drives in ship models

• Channel sequencer for automating servo motion

sequences of up to three servos, e. g. to automate

the lowering of landing gear or to extend/retract

drives in self-launching gliders

• Multi-channel function for operating Graupner

product line NAUTIC modules

• Digital trimming with pseudo »analog« endless

pinions, effective per speciﬁ c ﬂ ight-phase

• Auto-trim function. The current stick positions

for trimming ﬁ xed-wing or helicopter models will

be stored in trim memory at the press of a but-

ton. (Model »compensation«, activate switch and

release stick. The correction will be blended in

»gently« upon return of the stick.

• C1 changeover, brake/elec. motor: This changeover

can be implemented very easily via enhanced ﬂ ight

phase programming. The pilot determines the stick

positions (forward/rear) at which the motor is to

switched off or the airbrakes are to be retracted.

• 16 control functions maximum

• Simpliﬁ ed arrangement of operating elements,

such as sticks, external switches, proportional

controls and trim levers as control functions

• Protection against obsolescence is provided by

virtue of a fast 32-bit operating system with mod-

ern ﬂ ash memory that can be updated.

• Blue back-lighted MULTI-DATA-GRAPHIK-LCD

monitor with signiﬁ cantly better legibility under

unfavorable light conditions

• CONVENIENCE MODE SELECTOR to simplify

changeovers between operating modes 1 … 4

(e. g. throttle left/throttle right)

• Twelve freely programmable mixers for ﬁ xed-wing

or helicopter models, each with freely selectable

input and output functions; four curve mixers with

innovative 8-point curve technology for easy to set

and adjust curve values at up to eight points for

throttle, pitch, tail or other non-linear character-

istics. The arithmetic unit in the CPU employs an

ingenious method of calculating polynomial ap-

proximations for truly-rounded, ideal MPC (multi-

point curve) mixer curves

• Shifting curve mixer points can be done along

both axes with the CAP touch pad keys

• Eight ﬂ ight-phase programs can be individually

adapted for each model and given a name. The

As many as four servos can be controlled simulta-

Auto-trim function. The current stick positions

Computer System mc-32

32 channel remote control set in 2.4 GHz Graupner-HoTT technology

(Hopping Telemetry Transmission)

switchover time is programmable separately.

• SUPER SERVO menu with a perfect overview of

all servo setting data and simple parameter cor-

rection at four "levels": direction of rotation, mid-

point setting, separate servo travel on both sides

and separate travel limiting on both sides for 16

servos with a total of 96 setting options

• SUPER-DUAL-RATE, EXPO and EXPO/DUAL-

RATE menu with 36 potential setting variants for

three servo functions and six ﬂ ight phases

• Practice-optimized multi-function menu for aero-

foils and helicopter models. Entry of the number

of aileron and ﬂ ap servos automatically programs

all necessary mixer functions in the multi-function

"Wing mixers" menu. Differential aileron mixer,

butterﬂ y mixer, dual-ﬂ ap mixer, automatic gyro set

function and other special functions

• Helicopter swashplate mixer for 1, 2, 3, or 4 point

steering.

• Selectable cycle time: 10 ms or 20 ms/30 ms,

depending on receiver and operating mode

• A convenient timers menu with a system of eight

stopwatches, alarm timer, countdown timer, laps

counter and so on. Two running timers and one lap

timer can be displayed at the same time in large

characters.

• Stopwatch with history: In addition to the lap coun-

ter there is a "Time 1" which captures the switch-

on time and a "Time 2" which records the ON and

OFF times separately

• Channel mapping in the receiver allows free distri-

bution of control functions.

• The travel distance and rotation direction settings

integrated into the receiver make it possible, for

example, to match up mapped servos with one

another

• The programmable fail-safe functions »Hold«,

»Off« and »Move to preset positions« that are built

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Graupner MC 32 HOTT in the language / languages: English as an attachment in your email.

The manual is 46,26 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Graupner MC 32 HOTT

Graupner MC 32 HOTT User Manual - German - 320 pages

Graupner MC 32 HOTT User Manual - Dutch - 328 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Graupner MC 32 HOTT Manual

Product: