747993
23
Zoom out
Zoom in
Previous page
1/80
Next page
23 / 80
33028_mc_28_Teil2_jh
Is the position of the receiver antennas correct?
Are there any interference from electronic component in the
model?
If you have verified these conditions and you could not perform a
successful range test, then please contact our Customer Service (see
section "Service Center").
DSC port
The DSC output selection influences the number of control channels
available at the DSC port. The selection means:
PPM10 = Channel 1 - 5
PPM16 = Channel 1 - 8
PPM18 = Channel 1 - 9
PPM24 = Channel 1 - 12
Throttle Cut
This function is only available if "forward" or "backward" is set in the
Motor to CH1 option in the “Model type” menu.
With this function the throttle channel (CH1) can be switched while
holding a specific position (-100%). The motor will not start acciden-
tally, regardless of the position of the throttle stick.
In the left column set the position for the throttle channel (CH1)
switch. In the third column you can set the switch threshold. Move
the stick to the desired position and tap on the SET button. The
switch range will be set.
In the right column you can assign the desired switch. Proceed as fol-
lows:
Tap on the SET button in the "Thr.cut" line.
Move the desired switch to the position for the motor to be
switched off. Combinations with logical switches are also possi-
ble.
Base setup model
SEL
Rcv Ch Map R12 R08
RF transmit ON
RF Tange Test 99sec
DSC Output PPM10
Base setup model
SEL
RF transmit ON
RF Range Test 99sec
DSC Output PPM10
–––
cut off +150%–100%
STO
Move desired switch
to ON position
(ext. switch: SET)
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner MC-28 4D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner MC-28 4D in the language / languages: English as an attachment in your email.

The manual is 17,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info