354527

Gram ksi 200 00 g Manual

26
Zoom out
Zoom in
Previous page
1/40
Next page
26
6b
9
10
10a
12
Remove the kitchen element door and attach the
bracket 1 by screwing four screws 10 into
the pre-drilled holes . Attach the kitchen
element door to the appliance door. See .
The position of the door can be adjusted by turning
screw 7 using a cross-slot screwdriver.
After adjustment, fasten the door in position using
the bolt 8 .
Attach the bracket 3 to the bottom corner of the
appliance door using screw 12 and then to the
kitchen element door using screw 10 .
Attach the decorative strip 2 to the adjustable
bracket 1 .
You can change the doors from
right-hinged to left-hinged or vice
versa yourself
Remove the hinges from the appliance and refit
them as follows: upper right hinge to lower left of
door; lower right hinge to upper right of door.
Starting up
If during transport the appliance has been laid
down, or if it has been stored in cold surroundings
(colder than +5°C) it must be allowed to stabilise
for at least two hours before being switched on.
Start the appliance by plugging it into a wall socket.
Please note! If the mains lead has been
damaged, it must be replaced with a
corresponding type supplied by Gram A/S or
one of Gram’s service centres.
GB
Changing the temperature
When the appliance is started the thermostat should
be in its middle setting. After an hour or two the
cabinet will have cooled down. If a lower
temperature is required, turn the thermostat knob
towards „Max.”. If a higher temperature is
required, turn the knob towards „0”.
Refrigeration is switched off when the thermostat
knob setting is „0”.
Changing the temperature
Make two marks using the accompanying template
4 .
Attach the bracket 1 to the door at the marks
using two screws 10 . See figure .
Centrally position the appliance door on the kitchen
element door.
8
8a
13
16
The control panel is positioned behind the door at the
top of the cabinet. The switch furthest to the right
starts the freezer. The green lamp lights up, showing
that power is on. The thermostat knob can be set
from 1 (warmest) to 7 (coldest).
When the appliance is started the thermostat should be
in its middle setting „4”. After an hour or two the cabinet
will have cooled down. If a lower temperature is required,
turn the thermostat knob towards „7”. If a higher
temperature is required, turn the knob towards „1”.
The compressor is switched off when the thermostat
knob setting is „0”.
The red lamp lights up when the temperature in the
cabinet is not in accordance with the thermostat setting.
Freezing down
The most effective freezing down is achieved by pressing
the „quick-freeze” switch ¹ 24 hours before items are to
be placed in the cabinet. The yellow lamp º remains lit
for as long as „quick-freeze” is switched on.
When freezing down is completed - after a day or two
depending on the quantity of items placed in the cabinet
- switch off „quick-freeze”, and the yellow lamp
will go out.
Please note! The compressor runs conti-
nuously during freezing down.
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gram ksi 200 00 g at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gram ksi 200 00 g in the language / languages: English, Danish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info