354527

Gram ksi 200 00 g Manual

25
Zoom out
Zoom in
Previous page
1/40
Next page
25
GB
Recess dimensions
TYPE
KSI 200
FSI 170
Min. dimension (mm)
1226
562
550
Height
Width
Depth
4
2
See also figures .
The appliance must not be laid horizontally while
being transported or moved. If the appliance has
been tilted more than 40°, the power supply must
not be connected until the appliance has stood
upright for at least two hours.
3
Electrical connection
The appliance is intended for connection to
alternating current.
The connection values for voltage (V) and
frequency (Hz) are given on the nameplate in the
cabinet.
Power must be connected via a wall socket with
switch. The wall socket should be easily
accessible.
All earthing requirements stipulated by the local
electricity authority must be observed. The
appliance plug and wall socket should then give
correct earthing. If in doubt, contact your local
supplier or an authorised electrician.
WARNING
The flexible cord (mains lead) fitted to this appliance
has three cores for use with a 3-pin 13-amp or 3-
pin 15-amp plug. If a BS 1363 (13-amp) fused plug
is used, it should be fitted with a 13-amp fuse.
IMPORTANT
The cores in this mains lead are coloured in
accordance with the following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
These colours might not correspond with the colour
markings identifying the terminals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW core to the
plug terminal marked „E” or by an earth symbol, or
coloured GREEN or GREEN-AND-YELLOW.
Connect the BLUE core to the plug terminal
marked „N” or coloured BLACK. Connect the
BROWN core to the plug terminal marked „L” or
coloured RED.
Installation
For a list of screws and fittings, see page 35.
Insert the appliance into the recess and push its
door hinge side against the recess wall, .
Fasten the appliance securely to the recess wall
using two screws 11 in each hinge. Also
fasten the appliance to the base of the recess using
two screws 10 , .
Position the upper covering strip 5 between the
appliance and the top of the recess and fasten it securely
to the recess top using three screws 10 , .
Cover the ventilation opening between the
appliance and the bottom of the recess with the
base strip, 6 , and fasten it in place using two
screws 10 . Finally, cover the screw heads
with caps 14 . Screw the adjusting screws
7 into the two pre-drilled holes on the upper edge
of the door . As shown in figure , or
, it is easiest to assemble the door while it is
lying flat.
6
5
4
6
8
7
8a
8b
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gram ksi 200 00 g at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gram ksi 200 00 g in the language / languages: English, Danish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info