313379
19
Zoom out
Zoom in
Previous page
1/24
Next page
231737
19
Failure Possible cause Remedy
Excessive foaming
during washing.
Excessive measure of detergent. Use washing powder according to
the instructions by the producer and
according to the water hardness and
soiled laundry. Use only detergents for
machine washing.
FAILURE 7
Water is poorly
pumped out or not at
all (machine reports
failure - the LEDs
periodically ash seven
times).
Water outlet is clogged Check if:
• the lter is clean,
• outlet pipe is not jammed,
• the drain is clogged,
• outlet pipe is positioned higher than
1m.
Push START again
Laundry is not properly
spun.
No failure is reported.
The machine switched on the
UKS function. Because of bad
laundry balance, the machine
has automatically reduced spin
RPM.
The machine operates normally. Wash
large and small pieces of laundry
together.
Greasy wads appear
on the laundry.
Too little detergent (laundry was
very greasy).
Wash the laundry again.
Add more detergent for such soiled
laundry, or use liquid detergent.
Laundry is stained
after washing.
You used liquid detergent or
detergent for colored laundry
which does not contain whitener.
Use the detergent containing whitener.
White powdery
residues on the
laundry.
It is not the consequence of bad
rinsing, but because of neo-
phosphate detergents containing
non soluble components
(zeolites) for water softening.
Such substances may be
deposited upon the laundry.
Immediately rinse the laundry once
again.
Use liquid detergents which do not
contain zeolites.
Try removing the residues with the
brush.
Detergent residues in
the dispenser.
Low water ow pressure.
Some detergents may stick to the
dispenser rather hard if it is wet.
Clean the inlet pipe lter net.
In case of low water pressure
increase water level.
• Wipe the dispenser prior loading
detergent.
Softener is not
completely rinsed,
or water is left in the
dispenser dish.
Sucking cover is not correctly
positioned or is clogged.
Clean the dispenser and rmly x the
cover to its place.
Unpleasant smell in the
washing machine drum.
Remains of fabrics, washing
agent and softener in the lter.
• Development of germs
Check whether the lter is clean.
Run the Cotton 95°C program
without any laundry, using a powder
detergent.
19


Need help? Post your question in this forum.

Forumrules
1

Forum

gorenje-wa-61111

Reset search

  • Hi Friends,

    I have a Gorenje WA 61111 Washing Machine. We experienced a power surge which blasted of the top of a 7-pin IC on the electronic card, I wish to replace the IC and a resistor and a diode on the reverse side of the electronic card but I cannot see the number on the IC; I’d be very grateful if someone would not mind to help me to identify the IC (part number of the IC) please.

    Warm Regard,
    Paul.
    itododpo@yahoo.com Submitted on 21-8-2023 at 19:44

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje wa 61111 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje wa 61111 in the language / languages: English as an attachment in your email.

The manual is 2,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info