313379
18
Zoom out
Zoom in
Previous page
1/24
Next page
231737
6 - Six ashes: Heater failure
In these cases, turn off the machine, then turn it back on and repeat the program. If the failure
reoccurs, contact your nearest authorized service center. The LEDs will continue to ash until the
machine is turned off.
Interferences from the ambient (for example electrical wiring) could induce signalization of different
faults. In such cases:
- switch the appliance off, and wait for a few seconds;
- switch the appliance back on and repeat the washing program.
If the fault repeats, call authorized service shop.
Warranty shall not apply in case of failures due to interferences from the environment (lightning
stroke, power supply circuit faults, natural disasters).
18
Failure Possible cause Remedy
The machine does not
work (symbols are not
illuminated).
Machine is not powered. Check if:
• power in the socket,
• the fuse is OK,
• plug is in the socket.
FAILURE 2
Washing program does
not start
At the beginning of
the washing program:
on/off LED is ashing
• During washing:
LEDs periodically
ash twice
Door is not properly closed. Push it towards the machine.
FAILURE 3
Water does not enter
the machine (after
approx. 4 min the
machine reports failure
- LEDs periodically
ash three times).
Disturbed water inlet.
Check if:
• the water tap is open,
• inlet pipe net lter is clean.
Push the START button.
Water is leaking from
the machine.
• Filter is not tightly screwed in.
• Inlet pipe is not tightly screwed
to the machine or to the water
faucet.
• Outlet pipe fell to the oor.
• Tighten the lter properly.
• Tighten the inlet pipe.
• Af x the outlet pipe to the drain.
The machine moves
during operation.
• The machine is not properly
leveled.
• Transport brackets are not
removed.
• Level the machine with the
adjustable legs.
• Remove transport brackets.
The machine vibrates
during the spin.
Unevenly distributed laundry,
especially with very small
quantities (for ex. only the
bathrobe).
This is normal, the machine will
reduce the RPM if vibrations are too
strong.
Wash larger quantity of laundry.
18


Need help? Post your question in this forum.

Forumrules
1

Forum

gorenje-wa-61111

Reset search

  • Hi Friends,

    I have a Gorenje WA 61111 Washing Machine. We experienced a power surge which blasted of the top of a 7-pin IC on the electronic card, I wish to replace the IC and a resistor and a diode on the reverse side of the electronic card but I cannot see the number on the IC; I’d be very grateful if someone would not mind to help me to identify the IC (part number of the IC) please.

    Warm Regard,
    Paul.
    itododpo@yahoo.com Submitted on 21-8-2023 at 19:44

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje wa 61111 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje wa 61111 in the language / languages: English as an attachment in your email.

The manual is 2,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info