346134
6
Zoom out
Zoom in
Previous page
1/7
Next page
Instructions for Use
22
Cleaning the Appliance
Disconnect the power supply before cleaning the
appliance. Do not use coarse or aggressive cleaning agents
as you can damage the surface. Be careful to remove any
cleanser agent remaining after cleaning.
Clean the exterior with water and detergent.
Varnished surfaces are cleaned with soft cloth and an
alcohol based cleaning agent (for example glass cleaners).
You may also use alcohol (ethanol or isoprophylic alcohol).
The application of abrasive and specially aggressive
cleaners, such as the stainless steel cleaners, is not
appropriate for the cleaning of plastic and coated parts.
Remove the detachable accesories in the interior of the
appliance and clean it with water and liquid detergent.
Plastic parts cannot be washed in washing machine.
Wash the interior of the appliance with lukewarm water, in
which you added one or two spoonfuls of vinegar.
Every now and then wipe the condenser on the rear wall.
Use soft non-metal brush or vacuum cleaner.
Do not forget to clean also the defrost water receptacle
above the refrigerator compressor (do not remove the
receptacle).
After cleaning, connect the appliance to power supply and
reload the packages.
Switch Off the Appliance When Not In Use
If you do not intend to use the appliance for a longer period, set
the thermostat knob to the STOP position, disconnect the
power supply, take out the foods and defrost and clean the
appliance. Leave the door slightly open.
Trouble-Shooting Guide
During the service, you can come across some troubles that in
most cases result from improper handling of the appliance and
can easy be eliminated.
The Appliance Fails to Operate After connecting to the Mains
Supply
Check the supply in the outlet socket and make sure the
appliance is switched on (thermostat in operating position).
Continuous Operation of the Refrigerating System
the door was frequently opened or it was left opened for too
long;
the door is not properly closed (the door may sag, the gasket
may be polluted or damaged);
perhaps you have overloaded the appliance with fresh foods;
The reason may be inadequate ventilation of the compressor
and condenser (assure adequate air circulation and wipe off
the condenser);
Ice Formation on the Inner Rear Wall
As long as the defrost water runs to the channel and through
the opening to the drain pan on the compressor, automatic
defrosting of the appliance is assured.
In case the ice formation on the inner back wall is increased (3-
5 mm), ice should be manually defrosted.
Set the thermostat knob to STOP position and leave the door
open. Never use electric devices for defrosting and do not
scrape the ice or frost layer with sharp objects.
After completed defrosting, turn the knob to desired position
and close the refrigerator door.
The cause of increased ice formation may be one of the
following:
the door does not seal well (clean the gasket if it is
contaminated, or replace it if it is damaged);
the door was frequently opened or it was left opened for too
long;
the food stored in the refrigerator was warm;
the food or dish is touching the inner back wall.
Water is Leaking From the Refrigerator
In case the discharge water outlet is clogged, or the defrost
water drips over the channel, water leaks from the refrigerator.
Clean the clogged opening, for example with a plastic straw.
Manually defrost the increased ice layer. See Ice Formation
on the Inner Back Wall.
Noise
Cooling in refrigerating-freezing appliances is enabled by the
refrigerating system with compressor, which produces noise.
How noisy the appliance is depends on where it is placed, how
it is used and how old the appliance is.
During the operation of the compressor the noise of liquid
is heard and when the compressor is not operating, the
refrigerant flow is heard. This is a normal condition and it
has no influence whatsoever on the lifetime of the appliance.
After starting the appliance, the operation of the
compressor and the refrigerant flow may be louder, which
does not mean that something is wrong with the appliance
and it has no influence on the lifetime of the appliance.
Gradually the noise is reduced.
Sometimes unusual and stronger noise is heard, which is
rather unusual for the appliance. This noise is often a
consequence of inadequate placing.
The appliance shall be placed and levelled firmly on solid
base.
It should not touch the wall or kitchen units standing next
to it.
Check the accesories in the interior of the appliance, they
should be placed correctly in their positions; also check
the bottles, tins and other vessels that might touch each
other and rattle.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje ri 1442 la at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje ri 1442 la in the language / languages: English as an attachment in your email.

The manual is 0,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info