603646
25
Zoom out
Zoom in
Previous page
1/36
Next page
285764
SYMPTOM POSSIBLE CAUSE SOLUTION
A fuse blows as soon as the
hob is switched on.
The hob has been wrongly
connected.
Check the electrical
connections.
The hob simply switches off. You accidentally touched the
On/Off button or touched two
buttons at the same time.
Switch the hob back on.
Fault code ER22. The control panel is lthy or
has water on it.
Clean control panel.
Fault code E2. The hob has overheated. Let the hob cool down and then
use a lower setting.
Fault code U400 The voltage is too high
and/or the hob is not properly
connected.
Have your connection changed.
Fault code
.
You held a button too long. Do not hold the button too long.
Other fault codes. Defective generator. Contact the service
department.
Safety instructions for the installation
The connection must comply with national and local
regulations.
The appliance must always be earthed.
This appliance may only be connected by a competent
electrical installer.
For the connection, use an approved cable in accordance with
the regulations. The cable casing should be of rubber.
The connection cable must hang freely and is not to be fed
through a drawer.
If you want to make a xed connection, make sure that a multi-
polar switch with a contact separation of at least 3 mm is tted
in the supply line.
The worktop the hob is built into must be at.
The walls and the worktop surrounding the appliance must be
heat resistant up to at least 85 °C. Even though the appliance
itself does not get hot, the heat of the hot pan could discolour
or deform the wall.
Damage caused by incorrect connection, installation or use,
will not be covered by the guarantee.
25
Installation instructions
What you need to
consider
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje IT1141 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje IT1141 in the language / languages: English as an attachment in your email.

The manual is 3,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info