512706
13
Zoom out
Zoom in
Previous page
1/26
Next page
Instructions for use and connection
44
Safety functions and error display
The hob is equipped with the overheat safety
sensors. When they are activated they turn off the
hotplates nearest to the control board.
Error, possible cause, remedy
Constant sound signal or Err 33
Water is spilled over sensor surface
(Wipe the sensor surface)
Flashing »H«
Hot pan is placed above the sensor surface.
(Wait until normal sensor temperature is
regained.).
Gaskets on heating elements are damaged.
(Wait until normal sensor temperature is
regained.).
In case any other error signal is displayed,
switch the hob off immediately, disconnect it
from the mains and contact your nearest
service center.
Accessories
Deep frying pan is used for baking pastry and for
roasting meat.
Do not insert the deep frying pan into the bottom
guide.
Enameled tray is used only for baking pastry.
Put the food in a pan and place it on the shelf.
Food can be placed directly on the wire shelf as
well, but don't forget to insert the drip tray under it
to collect the drippings.
Protective shield is used when you cook in the
oven with the door open (infra red grilling).
The pull-out slides enable you to choose 3
different shelf positions for baking.
Put the grid or baking pan carefully on the
selected pair of pull-out slides between the
elements restricting the baking pan. This can be
done when the pull-out slides are pushed into the
oven or their relevant pair is drawn from the oven.
When these slides are drawn out, check whether
the baking pan or the grid is correctly placed on
the pull-out slides and then push them slowly into
the oven. Close the door ONLY when the slides
will be entirely inserted in the oven.
WARNING: be careful not to get burnt as during
preheating and baking process the pull-out slides,
grids and baking pan can heat up strongly.
If baking pan or grid is pulled out when baking by
the pull-out slides, please, use the baking handle
or protection glove provided.
Before closing the oven door check if the pull-out
slides are pushed well into the oven.
Warning: make sure the appliance is installed in
a perfectly horizontal position, otherwise the
telescopic guides may run out of the oven when
the door is open.
Place the grease filter always in position when
the oven is in the heating mode with the fan on,
since the possibility to stain the oven walls is the
biggest (spurting of fat during roasting). This way
the fan is also protected from staining.
When removing the tray from the oven, use the
handle. Hook the handle to the edge of the tray
and pull it out slightly lifted. Use the handle for
removing the wire shelf as well.
The rear wall of the oven is coated with catalytic
coating which can be installed or removed by a
qualified technician only.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje HEC50EP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje HEC50EP in the language / languages: English as an attachment in your email.

The manual is 1,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info