603276
11
Zoom out
Zoom in
Previous page
1/20
Next page
266871
Important warnings
Installation of the appliance into a kitchen worktop and its connection to the power mains may
only be performed by an adequately quali ed technician.
Veneer or other nish of the piece of kitchen furniture into which the hob is to be built in should
be treated with heat resistant glue (100°C); otherwise, the worktop nish may be discolored or
deformed.
Cooking hob is dimensioned to be built into the worktop over a piece of kitchen furniture, with a
width of 600 mm or more.
After installation, the front two fastening elements should be freely accessible from below.
The kitchen furniture element underneath the hob should not be tted with a drawer. If the
kitchen furniture element as a horizontal partition wall, it should be installed no less than 10
centimeters from the lower surface of the worktop. The space between the partition wall and the
hob must be empty; no objects should be placed into that gap.
Hanging, or wall-mounted kitchen elements should be installed high enough not to interfere with
the work process.
The distance between the cooking hob and the kitchen hood should be no less than indicated in
the instructions for kitchen hood installation. The minimum distance is 650 mm.
The distance between the appliance edge and the adjacent tall kitchen furniture element should
amount to no less than 100 mm.
Use of massive wood decoration plates or boards on the worktops behind the cooking hob is
permitted, if the minimum distance remains the same as indicated in the installation drawings.
Minimum distance between the built-in cooking hob and the rear wall is indicated on the
installation drawing.
Cooking hobs can be installed into worktops that are 30 to 50 mm thick.
Before inserting the appliance into the opening in the kitchen
worktop, the supplied foam gasket must be attached to the lower
side of the glass ceramic (glass) cooking hob (see gure above).
Do not install the appliance without the foam gasket!
The gasket should be attached to the appliance in the
following way:
- Remove the protective lm from the gasket.
- Then, attach the gasket to the lower side of the glass,
approximately 2-3 millimetres from the edge (as shown in the
gure). The gasket must be attached along the entire length of
the glass edge and should not overlap at the corners.
- When installing the gasket, make sure that the glass does not
come into contact with any sharp objects.
Installing the foam
gasket
11
Installation
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje GHS64-ORA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje GHS64-ORA in the language / languages: English as an attachment in your email.

The manual is 1,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Gorenje GHS64-ORA

Gorenje GHS64-ORA Usermanual and installation guide - German - 13 pages

Gorenje GHS64-ORA Usermanual and installation guide - Dutch - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info