330546
7
Zoom out
Zoom in
Previous page
1/29
Next page
Instructions for use, installation and connection
39
Selection and setting of oven
temperature
After selecting the type of food and oven function
mode, by pressing the sensors (3a/3b) you may
select the desired oven temperature in the range
from 30 – 250°C (depending upon the selected
operation mode) in 5°C intervals.
During the operation, oven temperature may
be randomly increased or decreased within
the permitted temperature range (see chart)
by pressing the sensors (3a/3b).
Table of data for operation mode (with a sensor 2)
Operation mode
Preset
temperature (°C)
200 160 200 170 250 160 160 150 -
Preset time
(h/min)
---------
Possibillity of max.
set temperature (°C)
250 250 250 250 250 220 220 200 -
Oven thermostat signal lamp (d3-2)
Signal lamp is on; oven temparture is below the
setting and the oven is heating.
Signal lamp is off; the temperature in the oven
has reached the set temperature.
Signal lamp is flashing regularly; the oven is set
to the end of operation mode with the adequate
sensor (d4-2); the preparation of food has not
started as yet (the appliance automatically
computes the relevant moment of starting the
oven operation).
Setting the operation time
The time of oven operation may be selected in
the range from 0 to 6 hours, in 1 minute
intervals.
After selecting the function mode and the
temperature, by pressing the sensor 4 you may
now select the operation time from 0 to 6 hours,
in 1 minute intervals.
Touch the selection sensor (4), the display
(d4-1) starts flashing. By touching sensors
(4a/4b) set the desired operation time.
Turn the oven on with the ON/OFF sensor (5).
When the set time has elapsed, the oven is
switched off (signalled by the beep, oven
operation time symbol (d4-1) and the relevant
signal lamp (5a) are flashing).
By touching any sensor (except the ON/OFF
sensor (5), which turns the sound signal off and
switches the oven on) you may switch the
sound signal off, otherwise it is turned off
automatically after 7 minutes.
Oven operation time may be changed during
the operation.
Setting the end of operation time
This function is used when you wish to select
the end of operation (cooked food) at exactly
the pre-selected time.
The function may be used only with previously
set time of operation ((d4-1) is on).
By touching the selection sensor (4) symbol
(d4-2) flashes, and the display (d4-6) flashes
the sum of daily current time and the oven
operation time. Use the sensor (4a) to set the
desired end of oven operation.
Switch the oven on with the ON/OFF sensor
(5). The appliance awaits the start of operation
(oven thermostat signal lamp symbol flashes
regularly (d3-2), oven operation time symbol is
on (d4-1) and end of operation time symbol
(d4-2) is also on.
The starting time is now defined automatically.
At the moment the oven starts the operation,
the end of operation symbol (d4-2) goes off,
oven illumination is on, and the oven thermostat
signal lamp (d3-2) is on until the set
temperature is reached.
Eventual immediate start of operation may be
provoked by simultaneous pressing of sensors
(4a/4b) (for approximately 5 seconds).
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gorenje b 50 ep at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gorenje b 50 ep in the language / languages: English as an attachment in your email.

The manual is 0,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info