656039
2
Zoom out
Zoom in
Previous page
1/5
Next page
battery contact due to the irregular shape of the battery contacts.
If you change the batteries after firing many flashes continuously, be
aware that the batteries might be hot.
Using size-AA batteries other than the alkaline type may cause improper
Recycling Time and Flash Count
Take AA alkaline batteries (LR6)
as an example:
Based on new size-AA alkaline batteries.
The battery level indication on the LCD panel will blink if the remaining battery level
is too low to be charged. Please replace the batteries.
Recycling Time
Approx. 0.1–5sec
Flash Count
Approx. 100-700
batteries, replace all four at one time.
Size-AA Ni-MH or lithium batteries can also be used.
Use a new set of four batteries of the same brand. When replacing the
1. Always keep this product from rain or damp to avoid fire or
electric shock.
2. This device contains high-voltage electronic parts inside. Do
not disassemble or repair it. If you touch the high-voltage
circuit inside the product, electric shock may occur. Send it to
the authorized maintenance center for repair if needed.
3. Stop using this device if it breaks open due to extrusion,
falling or strong hit. Otherwise, electric shock may occur if you
touch the electronic parts inside it.
4. Do not fire the flash direct to the eyes (especially those of
babies) at short distance, or it may damage eyes. When taking
picture for babies, it is recommended to keep the flash unit at
least 1 meter (3.3 feet) away from them. Using bounce flash to
reduce light intensity is also suggested.
5. Always keep batteries or anything that may pose an
ingestion hazard out of children’s reach. Please contact a
doctor immediately if ingestion occurs.
6. When there is caustic liquid leakage inside, wear gloves
before taking out batteries.
7. Do not use the flash unit in the presence of flammable gas,
chemicals and other similar materials. In specific circumstance,
these materials may be sensitive to the strong light emitting
from this flash unit and may cause fire or electromagnetic
interference. Please pay attention to the warning marks in the
shooting surroundings.
8. Do not leave or store the flash unit in temperature over 40°C
(e.g. in automobile), or it may damage the electronic parts.
9. The flash unit is not waterproof. Please keep it away from
rain or humidity.
10. Please take out all batteries and keep the flash unit in dry
places if it will remain unused for long.
WARNING
Built-In Wide Panel
Flash Head
Optic Control Sensor
Charging Socket
Socket Cover
Hot Shoe Stand
Hot Shoe Contact
Lock Ring
Reflection Card
PC Sync Socket
I. Name of Parts
Accessories
To achieve better performance and light effects, Thinklite camera
flash can be operated with such products as, PB960 power pack,
honey comb, color filter, etc.
Mini Stand
Mode Selection
Power Switch
LCD Panel
Zoom Selection
C.Fn Custom
Function
+” Button
Set Button
Test Button/
Flash Ready Indicator
-” Button
SLAVE Selection
Battery
Compartment
1.Installing the Batteries
Install four-size AA batteries.
1. Open the cover.
Use your thumb to press the
battery compartment cover, and
then slide it to open the cover.
2. Install the batteries.
battery contacts are properly
oriented as shown in the
compartment.
Make sure the "+" and "–"
3 Close the cover.
cover as shown by the arrow to
close it.
.
Slide the battery compartment
II. Installation
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Godox TT660 II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Godox TT660 II in the language / languages: English as an attachment in your email.

The manual is 1,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info