505290

General Electric GCG1520 Manual

14
Zoom out
Zoom in
Previous page
1/20
Next page
If the toe plate rubs the floor covering, the toe
plate clearance may be changed as follows:
Mark on each side of the toe plate the
amount of toe plate that rubs the floor
covering.
Remove the drawer from the unit.
See
Step 3.
Use a ruler and a pencil or chalk to draw a
line between the marks on each side of toe
plate.
Use scissors or utility knife to cut toe plate
along line.
Replace drawer.
See Step 10.
If toe plate
still rubs floor covering, repeat these steps.
5
4
3
2
1
Installation Instructions (cont).
Move the compactor close to its final position.
Plug the power supply cord into a properly
grounded receptacle.
Carefully lift the front slightly and roll
compactor into the cabinet opening until the
retaining brackets stop the unit.
Using the two #8 -18 x 1/2″ screws, fasten the
retaining brackets to the underside of the
countertop with the mounting screws. If the
brackets cannot be attached to the underside
of countertop, attach mounting clips to
brackets. Fasten compactor to cabinet front
with mounting screws through mounting clips
.
9
Grasp sides of compactor drawer and place bottom of drawer into tracks. Lift at the handle so
the front of drawer will go over drawer stops. Close drawer. Check if drawer opens freely. If the
toe plate rubs against floor, see section below.
10
Adjusting the Toe Plate
Lift here
Retaining
bracket
Mounting
screw
Retaining
bracket
Mounting
clip
Mounting
screw
14
Customer Service Troubleshooting Tips
Operating Instructions
Safety InstructionsInstallation InstructionsCustomer Service Troubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
Customer Service Troubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for General Electric GCG1520 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of General Electric GCG1520 in the language / languages: English as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info