479869
3
Zoom out
Zoom in
Previous page
1/3
Next page
EMERGENCY DISARMING AND TOTAL DISARMING BY
ELECTRONIC KEY
This kind of disarming has been conceived as an “EMERGENCY
DISARMING” and “TOTAL DISARMING”.
When placing the electronic key into the specific receptable, the alarm system
disarms and switches OFF; it will be not re-arm when the vehicle radio control
is used.
NOTE: it is possible to carry out the complete disarming procedure only when
the system is armed, during one alarm cycle or during the neutral time between
two alarm cycle but not during the arming neutral time.
To restore normal operation, it is necessary to put the electronic key into the
specific receptable and again during the arming inhibit time (led illuminated).
LED SIGNAL
CAUSE OF THE ALARM
ALARM CYCLE
NUMBER
5
Infinite
5
Infinite
5
Doors opening
Boot/bonnet opening
Cut wires
Volumetric sensors
Positive under key (+15/54)
LED ON (1second)LED OFF (2 seconds)
PAGE. 4
PAGE. 5
The LED will flash the code for a total of 5 cycles. This indication can be
interrupted by turning the ignition “OFF”
The possible alarm trigger signaling are indicated in the table reported below.
PROGRAMMING OF NEW ELECTRONIC KEYS
The alarm can be memorized max 4 electronic key.
! With the alarm being disarmed, turn the ginition key to “ON” position.
! Turn the ignition ket to “OFF” position.
! Re-turn the ignition key to “ON” for three consecutive times (ignition key to
“ON” and “OFF”), within the maximum time of four seconds.
! After the fourth commutation, let the ignition key to “ON”.
! The alarm will indicate the procedure starting of new electronic key learning
by two acoustic signals, one acute tone and the other loud tone, and two
long flashes of the status led.
! Introduce the electronic key to be self learned in the specific receptacle.
! The alarm will indicate the new electronic key learning by a status led
flashing and an acoustic signal.
! Repeat the procedure to save to memory other electronic key.
! Turn the ignition key to “OFF” position and remove from negative the
GREEN wire (or close the vehicle bonnet).
! The procedure completion will be indicated by one long acoustic signal and
a flash of the status led.
NOTE: Saving to memory the fifth device, has as a result the deletion of the first
device installed in the location one of the alarm memory.
Programming is directly depending on the earth connection of the bonnet
protection GREEN wire.
Therefore, if connection was not required, since bonnet opening is detected by
CAN-BUS signals, before starting new electronic key programming, connect
this wire to earth.
Proceed as described below:
WARRANTY CONDITIONS
This apparatus is guaranteed against all defects of fabrications for a period of
24 month from the installation date shown on this warranty coupon, taking into
consideration the 1999/44/CE.
Therefore, you are kindly requested to fill entirely the guarantee certificate
included in this booklet and to NOT REMOVE the guarantee label from the
device.
Missing or tearing of this label, missing of one part of guarantee certificate or
missing of the enclosed sale document, will invalidate the guarantee. The
guarantee is valid exclusively to Gemini Technologies S.p.A. Authorized
Service Centers.
The manufacturer will decline any responsibility for any eventual malfunctions
of the device, or electrical plant damages of the vehicle, due to improper
installation, use or tampering.
This alarm has exclusively a deterrent function against eventual thefts.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gemini 7733 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gemini 7733 in the language / languages: English as an attachment in your email.

The manual is 0,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info