813412

Gazco Studio Freestanding Balanced Flue Manual

19
Zoom out
Zoom in
Previous page
1/52
Next page
19
2.32 Carefully lift the appliance into position.
Take care not to damage the floor finish.
Ensure all clearances to combustibles are observed, see
Site Requirements, Section 6.
2.33 Connect the gas supply to the gas Inlet pipe at the back of
the appliance.
3. Flue Assembly
3.1 See Site Requirements, Section 2, Flue Options.
TAKE CARE WHEN MARKING OUT FOR THE FLUE AS
IT IS DIFFICULT TO MOVE AFTER INSTALLATION. IF A
RESTRICTOR IS REQUIRED FIT THIS BETWEEN THE
SMALL OUTLET SPIGOT AND THE AIR DUCT, SEE
DIAGRAM 14. REFER TO TECHNICAL SPECIFICATIONS
FOR RESTRICTOR SIZE.
14
3.2 A 152mm (6") diameter hole in the wall is required to install
the flue. This can be achieved by using either:
a) Core drill
b) Hammer and chisel
3.3 Drill small holes around the circumference when using
method b). Make good both ends of the hole.
3.4 Allow enough room either above or to the side of the
appliance to assemble the flue on top.
3.5 Assemble a horizontal flue in the following order:
— Vertical section
— 90° elbow
— Horizontal plus terminal
3.6 Support the opening of a masonry installation with a lintel.
3.7 Only the horizontal terminal section can be reduced in size.
To find the length:
3.8 Measure from the outside of the wall to the stop on the
90° elbow.
3.9 Add 10mm to the outlet end.
3.10 Measure from the edge of the slots closest to the wall.
3.11 Mark around the flue, see Diagram 15.
15
10mm
A wall plate is supplied to fix the flue to the wall:
3.12 Bend the tab to 90°.
3.13 Assemble the plate onto the flue but do not secure to wall
until the flue is fully assembled, see Diagram 15.
3.14 The cardboard fitment in the terminal is used to support the
flue whilst it is cut to length. ONCE CUT TO SIZE
REMOVE THE CARDBOARD REMNANT, see Diagram 16.
16
3.15 Remove the compression elbow from the appliance and
connect it to the gas supply pipe.
As the appliance is fitted into the enclosure:
3.16 Pass the elbow and supply pipe through the silicone panel
on the LEFT HAND side.
3.17 PURGE THE SUPPLY PIPE. This is essential to expel any
debris that may block the gas controls.
3.18 Connect the elbow to the appliance inlet pipe,
see Diagram 17.
17
Installation Instructions
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gazco Studio Freestanding Balanced Flue at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gazco Studio Freestanding Balanced Flue in the language / languages: English as an attachment in your email.

The manual is 8.63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info