647655

Garret Ace 200 Manual

9
Zoom out
Zoom in
Previous page
1/11
Next page
14
Garrett Metal Detectors ACE 200
™
15
SYMPTOM SOLUTION
No power
1. Ensure batteries are installed in the correct orientation.
2. Replace all old batteries with all new batteries.
Erratic sounds or
target ID cursor
movement
1. Ensure your searchcoil is securely connected and the coil
cable is snugly wound around the stem.
2. If using the detector indoors, be aware that excessive
amounts of electrical interference exists, plus excessive
amounts of metal can be found in floors and walls.
3. Determine if you are close to other metal detectors or other
metal structures such as electrical power lines, wire fences,
benches, etc.
4. Reduce your sensitivity setting.
Intermittent Signals
Intermittent signals typically mean you’ve found a deeply
buried target or one that is positioned at a difficult angle for
your detector to read. Scan from different directions to help
define the signal. In the case of multiple targets, switch to
the ZERO-DISC Mode to locate all targets. In trashy areas, use
the Super Sniper™ or a 5" x 8" DD searchcoil. NOTE: Iron
targets may cause Intermittent Signals. You can identify iron
targets in the ZERO-DISC Mode.
I’m not finding
specific targets
Ensure you are using the correct mode for the type hunting
you are doing. If specifically hunting for coins, COINS mode
should be your best choice to eliminate other undesirable
targets. You may also use the ZERO-DISC mode, which
detects all metal targets to ensure desired targets are present.
Target ID Cursor
bounces
If your Target ID Cursor bounces erratically, chances are
you’ve found a trash target. However, a Target ID Cursor may
bounce if a good target (such as a coin) is not parallel to the
searchcoil (e.g. on edge). It may also bounce if there is one
or multiple “junk” targets laying next to the good target. Scan
from different directions until your Target ID Cursor becomes
more stable.
NOTE: Large, flat pieces of iron—depending on their
orientation in the ground—can read as a good target or can
cause erratic Target ID Cursor movement.
TROUBLESHOOTING GUIDE
Low Battery
Indicator
BATTERY REPLACEMENT
The Low Battery Indicator will switch on when the detector's
batteries become weak. The detector will maintain full
performance but the batteries should be replaced soon when
this indicator appears. NiMH rechargeable batteries may be
used, but may have a shorter life per charge. You can expect
20 to 40 hours of operation depending on battery type and
quality.
Replace the batteries by sliding the cover off the control
housing. Remove batteries when the ACE 200 will be stored
for longer than 30 days.
Note: 1.5V/cell Lithium batteries can also be used, but the
use of 3.7V/cell Lithium batteries will damage the detector.
… 9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garret Ace 200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garret Ace 200 in the language / languages: English as an attachment in your email.

The manual is 3,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garret Ace 200

Garret Ace 200 User Manual - Spanish - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info