579857

Garmin GTN 650 Manual

102
Zoom out
Zoom in
Previous page
1/412
Next page
GTN 6XX/7XX AML STC Installation Manual 190-01007-A3
Page 3-22 Rev. 4
Complete the following steps to assemble the backshell onto the connector:
1. Attach the Shield Block (2) to the backshell (1) by inserting the flathead screws (3) through the
holes on the Shield Block and threading into the tapped holes on the backshell (1)
(See Figure 3-2).
2. Wrap the cable bundle with Silicone Fusion Tape (19 or a similar version) at the point where the
backshell strain relief and cast housing will contact the cable bundle.
3. Place the smooth side of the backshell strain relief (7) across the cable bundle and secure using
the three screws (6). Ensure that each half of the strain relief bar is supporting half of the cable
bundle.
CAUTION
Placing the grooved side of the strain relief across the cable bundle may damage wires.
4. For P1001, install the configuration module into the connector backshell. Refer to Section 3.6.3.2
for instructions on installing the configuration module into the backshell.
5. Attach the cover (8) to the backshell using two screws (9).
NOTE
Each tapped hole on the shield block (2) may accommodate only three ring terminals
(15). Two wires per ring terminal will necessitate the use of a ring terminal, #8,
insulated, 14-16 AWG (MS25036-153). Each hole in the shield block can accommodate
six shield drains.
6. Install ring terminals (15) onto the wires (13), grouping wires as appropriate for the connector.
7. Terminate the ring terminals to the shield block (2) by placing items on the pan head screw (16)
in the following order: split washer (17), flat washer (18), first ring terminal, second ring terminal
if needed, before finally inserting the screw into the tapped holes on the shield block.
8. Insert the assembled connector into the backplate. Using screws (6), secure the connector into the
backplate.
… 102 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin GTN 650 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin GTN 650 in the language / languages: English as an attachment in your email.

The manual is 8,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info