691441
6
Zoom out
Zoom in
Previous page
1/16
Next page
Speed
Shows the motor speed level (Adjusting the Speed of
the Motor, page 5).
Trolling motor
battery status
Green: the motor battery voltage is good.
Yellow: the motor battery voltage is low.
Red: the motor battery voltage is critically low.
GPS signal
status
Green: the motor has a good GPS signal.
Yellow: the motor has a poor GPS signal.
Red: the motor does not have a GPS signal.
Motor status
Shows the status of the trolling motor (Status
Indicator, page 2).
Power
Hold to turn the motor off.
NOTE: By default, the trolling motor turns on
automatically when it receives power. It is not
necessary to push this button to turn it on. This can be
changed in the settings (Trolling Motor Settings,
page 8).
The trolling motor turns off automatically when it is in
the stowed position for two hours.
When the propeller is turning, press to stop the
propeller.
Press three times to enter pairing mode.
Propeller
status
Illuminates when the propeller is on (Turning the
Propeller On and Off, page 5).
Heading hold
status
Illuminates when heading hold is on (Maintaining Your
Heading, page 6).
Anchor lock
status
Illuminates when anchor lock is on (Holding Your
Position, page 6).
Status Indicator
The LED indicates the motor status.
Green Normal operation
Red Solid: system booting
Blinking: system error
Blue Pairing mode
Yellow Recovery mode (for software updates and recovery
procedures)
Calibrating the Trolling Motor
You must calibrate the compass in the trolling motor before you
can use the autopilot features. For the best results, you should
calibrate the motor on a day with little or no wind on calm water.
You can repeat the calibration process if the autopilot features
are not performing as expected.
1
Drive the boat to an open area of calm water and stop
moving.
The boat must be stationary to begin the calibration process.
2
If necessary, deploy the trolling motor (Deploying the Motor
from the Stowed Position, page 1).
3
On the remote control, select > Settings > Trolling Motor
> Calibrate > Compass.
4
Using the foot pedal or outboard motor to steer, follow the on-
screen instructions.
Setting the Bow Offset
Based on the installation angle, the trolling motor may not align
with the center line of your boat. For the best results, you should
set the bow offset.
1
Using the remote control, adjust the angle of the trolling
motor so it aligns with the center line of your boat ,
pointing straight forward.
2
On the remote control, select > Settings > Trolling Motor
> Calibrate > Bow Offset.
3
Repeat this procedure if necessary.
Connecting to a Chartplotter
Your compatible Garmin
®
chartplotter must have the latest
software version installed before you can connect the trolling
motor.
You can connect the trolling motor wirelessly to a compatible
Garmin chartplotter on your boat. After you connect to a
compatible chartplotter, you can control the trolling motor from
the chartplotter in addition to the remote control and foot pedal.
1
Turn on the chartplotter and the trolling motor.
2
Make sure that the chartplotter is hosting a wireless network.
NOTE: If you have multiple chartplotters installed, only one is
the wireless network host. Consult your chartplotter's owner's
manual for more information.
3
On the chartplotter, select Settings > Communications >
Wireless Devices > Garmin Trolling Motor > Start.
4
On the trolling motor display panel, press three times to
enter pairing mode.
on the trolling motor display panel illuminates blue as it
searches for a connection to the chartplotter, and changes to
green when the connection is successful.
A confirmation message appears on the chartplotter when
the connection is successful.
5
After the chartplotter and trolling motor connect successfully,
enable the trolling motor bar on the chartplotter to control the
motor.
See the latest version of your chartplotter's owner's manual
for complete operation instructions.
Remote Control
Installing Batteries
The remote control operates using two AA batteries (not
included). Use lithium batteries for best results.
1
Turn the D-ring counter-clockwise, and pull up to remove the
cover.
2
Insert two AA batteries, observing polarity.
2 Remote Control
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin Force Trolling Motor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Force Trolling Motor in the language / languages: English as an attachment in your email.

The manual is 2,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garmin Force Trolling Motor

Garmin Force Trolling Motor Installation Guide - German - 8 pages

Garmin Force Trolling Motor User Manual - German - 18 pages

Garmin Force Trolling Motor Installation Guide - Dutch - 8 pages

Garmin Force Trolling Motor User Manual - Dutch - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info