63784
15
Zoom out
Zoom in
Previous page
1/32
Next page
Fishnder 90/140 Owner’s Manual 9
Installing Your Fishnder
To mount the transducer on a transom:
1. Position the transducer mount at the selected transom
location. Make sure the transducer is parallel with the
water line. Mark the center locations of each hole on the
transducer mount. (See the gures on the next page.)
2. Using a 5/32" bit, drill the pilot holes approximately 1"
(25 mm) deep at the marked locations. To avoid drilling
the holes too deep, wrap a piece of tape around the bit
at 1" from the point of the bit.
3. Apply marine sealant to the 5 x 30 mm screws. Attach
the transducer assembly to the transom using the 5 x 30
mm screws. Adjust the transducer assembly to extend
beyond the bottom of the transom approximately 1/8"
(3 mm) on berglass hulls or 3/8" (10 mm) on aluminum
hulls. Adjust the transducer assembly to be aligned
parallel with the water.
4. Tighten the 10-32 locking nut until it touches the
mounting bracket, and then tighten 1/4 turn more. (Do
not overtighten.)
5. Place the rst cable clamp on the transducer cable
approximately one third of the distance between the
transducer and the top of the transom. Mark the location.
Using a 1/8" bit, drill a pilot hole approximately 3/8" (10
mm) deep.
6. Attach the cable clamp using a 4 x 12 mm screw. Coat
the screw with marine sealant before installation. Repeat
steps 5 and 6 using the other cable clamp.
7. Route the transducer cable, as needed, to the Fishnder.
DO NOT CUT THE CABLE. Avoid routing the cable with
electrical wires or other sources of electrical interference.
190-00582-10_0A.indd 9 12/2/2011 3:08:58 PM
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin Fishfinder 90 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Fishfinder 90 in the language / languages: English as an attachment in your email.

The manual is 3,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info