63784
13
Zoom out
Zoom in
Previous page
1/32
Next page
Fishnder 90/140 Owner’s Manual 7
Installing Your Fishnder
4. Wrap the two ends of the cable tie around the motor
body. Place the pointed end of the cable tie through the
fastener hole on the opposite end and pull it through until
it is snug but not tight. (The cable tie clicks when you pull
it.)
5. Position the transducer so that it is parallel with the
bottom when in use, and make sure the gasket is aligned
properly. Pull the cable tie end until tight. Trim off the
excess, if necessary. Tighten the 10-32 locking nut until
it touches the mounting bracket and then tighten 1/4 turn
more. (Do not overtighten.)
6. Route the 20’ (6 m) transducer cable using the supplied
cable ties to secure the cable to the motor shaft. You
can ll the forward-facing portion (except the cable tie
pocket) of the transducer mount with sealant to avoid
accumulating debris.
Mounting the Transducer on a Transom
Tool List (not included)—drill, 3/8" wrench or socket,
5/32" and 1/8" drill bits, masking tape, #2 Phillips
screwdriver, and marine sealant.
When selecting a transom mount location, consider the
following for optimal performance:
For your sonar to operate properly, the transducer must
be located in calm water. DO NOT mount the transducer
behind strakes, rivet lines, struts, ttings, water intake,
discharge ports, eroding paint, or anything that creates
turbulence.
Mount the transducer as close to the center of the boat as
possible.
DO NOT cut the transducer lead. (This voids your
warranty.)
DO NOT mount the transducer in locations where it
might be jarred when launching, hauling, trailering, or
storage.
190-00582-10_0A.indd 7 12/2/2011 3:08:57 PM
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin Fishfinder 90 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Fishfinder 90 in the language / languages: English as an attachment in your email.

The manual is 3,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info