463797
4
Zoom out
Zoom in
Previous page
1/6
Next page
4 echoInstallationInstructions


1. Feed the cables
through the
5
/
8
in. (16 mm) center hole you drilled
when preparing the swivel-mount base.
2. Place the swivel-mount base
on the
mounting surface, route the cables through
the cable pass-through holes
, and
loosely fasten the swivel-mount base using
the appropriate screws or bolts
.
3. Place the swivel mount
on the swivel-
mount base, but do not fasten it.
4. Place the echo device or cradle into the
swivel mount (page 4).
5. Pull out enough slack from the power and
transducer cables so that the mount can
fully swivel to the desired positions when
the cables are connected.
6. Remove the echo device or cradle, and the
swivel mount, from the swivel-mount base.
7. Apply marine sealant to the
5
/
8
in. (16 mm)
center hole and to the cable pass-through
holes.
8. Securely fasten the swivel-mount base, using the appropriate screws or
bolts.
9. Place the swivel mount on the swivel-mount base, and fasten it using the
included 10 mm M6×1 Phillips screw
.


Complete this task only if you do not need to run the
cables through the mounting surface and the mount.
1. Place the swivel-mount base
on the mounting
surface, and fasten it using the appropriate screws
or bolts
.
2. Place the swivel mount
on the swivel-mount
base, and fasten it using the included 10 mm
M6×1 Phillips screw
.
3. Seal the cable pass-through holes
with marine
sealant.

1. With the locking arm
in the upward position, place the echo
100/150/300c device
or the echo 200/500c/550c cradle
into the
swivel mount
.
2. Tilt the mount for the desired viewing angle and press down on the
locking arm.


1. Route the power cable from the swivel mount to the boat battery or fuse
block.
If necessary, extend the wires using 20 AWG or larger wire.
If you connect the power cable to the fuse block, rst remove the
inline fuse holder on the red wire.
2. Connect the red wire to the positive terminal on the battery or fuse block,
and connect the black wire to the negative terminal.

On an echo 100/150/300c device, the connectors on the cables are keyed to
t only in the correct ports on the device.
1. Compare the divot
on the cable connector to the
keying on the device ports to identify the correct port.
2. Push the cable connector into the correct port until the
connector is fully seated.
3. Repeat steps 1 and 2 until all of the cables are connected
to the device.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin Echo 300C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Echo 300C in the language / languages: English as an attachment in your email.

The manual is 1,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Garmin Echo 300C

Garmin Echo 300C User Manual - English - 28 pages

Garmin Echo 300C Installation Guide - German - 8 pages

Garmin Echo 300C Quick start guide - German - 24 pages

Garmin Echo 300C Installation Guide - Dutch - 6 pages

Garmin Echo 300C User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info