724668
17
Zoom out
Zoom in
Previous page
1/38
Next page
45cc Petrol Chainsaw
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. YR-CS4500S • 04/2016 • 51488
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: help@powertoolsupport.com1800 909 909
45cc Petrol Chainsaw
MODEL: №. YR-CS4500S • 04/2016 • 51488
15
Assembly
CAUTION: A new chain (19) will stretch after just a few minutes of use.
Check and, if necessary, re-adjust the tool free chain tensioning dial (21).
A loose chain causes rapid wear to both the chain (19) and the guide bar
(18) and could derail causing a major safety hazard.
NOTE: Do not make ANY adjustments
with the chainsaw engine running.
Run the chainsaw for approximately
30 sec and then turn the chainsaw off.
Retest the chain.
Filling up with Fuel and Oil
WARNING: Fuel is very flammable. Avoid smoking or causing any
sparks or flames near fuel. Make sure that you stop the engine and
allow it to cool before refuelling the machine. Select outdoor bare
ground for fuelling and move at least 15m (49ft) metres away from the
fuelling point before starting the engine.
It is suggested to wear safety glasses when mixing fuel.
Only use oil that is expressly labelled for use with air-cooled 2-stroke
engines. DO NOT use BIA or TCW (2-stroke water-cooling type) mixed oil.
The recommended mixing ratio is PETROL 40: OIL 1
Use fresh unleaded fuel. Do not use ethanol based fuels.
Poor quality fuel or oil may damage sealing rings, fuel lines or the fuel tank.
Do not use waste or regenerated oil, it can damage the oil pump.
CAUTION. To maximise the lifetime of the engine, avoid the following:
Do not use raw fuel, it will severely damage the engine very quickly.
Do not run the tank dry during cutting, as this may cause damage to the
engine.
Do not use oil meant for 4-stroke engines, it will cause spark plug fouling,
exhaust blocking and piston ring sticking.
Do not use fuel mixtures that have been left standing for one month or
more, they can cause clogging of the carburettor.
Before storing the chainsaw for an extended period, empty the fuel tank
(7), clean it then run the engine to empty the carburettor at idle speed.
NOTE: Do not discard an unwanted fuel container with household waste.
It must be taken to an authorised repository site.
NOTE: The guide bar, chain, oil pump and oil lines contain oil after the
chainsaw has been run. OIL will drain freely from these component after
the chainsaw has been turned OFF. Be aware or it may spill on to the
surface the chainsaw has been placed so be careful where the chainsaw
is located for both storage and transportation.
TIGHT
LOOSE
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline YR-CS4500S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline YR-CS4500S in the language / languages: English as an attachment in your email.

The manual is 3,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info