724676
14
Zoom out
Zoom in
Previous page
1/28
Next page
S U A
1800 909 909
www.powertoolsupport.com email: help@globalpowerbrands.com
AFTER SALES SUPPORT
46460
14
5. Place the chain (2) around the drive sprocket wheel (23) with the chain links in the
direction shown on the bar and fit the chain around the guide bar. (Fig H&I)
6. Replace the chain drive cover on to the chainsaw and hold the cover on to the
chain bar. DO NOT SECURE WITH THE NUT. (Fig J)
7. Fit the securing nut and tighten FINGER TIGHT. Check again the cover is flat on the
surface of the bar. (Fig K)
8. While holding the cover on firmly, grasp the chain bar and slide the bar outward
slowly. When the chain tensioning pin aligns with the clearance hole in the bar,
the cover will drop firmly and flat on the bar. If the chain tensioning pin does not
align, adjust the tension screw so the pin aligns with the hole in the bar. The pin
must enter the bar before the nut is applied. (Fig L)
9. Tighten the chain tensioner screw (3) until the links of the chain just touch the
bottom edge of the guide bar. (Fig M)
11. Tighten the rear side cover locking knob firmly. (Fig N)
12. Tighten the chain drive side cover nut firmly. (Fig O)
Note. Ensure the engine is switched off when making any adjustments to the
chain and bar.
Getting Started
4
H
L
I
M
J
N
K
O
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline PCH25 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline PCH25 in the language / languages: English as an attachment in your email.

The manual is 2,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info