724676
13
Zoom out
Zoom in
Previous page
1/28
Next page
S U A
1800 909 909
www.powertoolsupport.com email: help@globalpowerbrands.com
AFTER SALES SUPPORT
46460
13
Getting Started
4
Unpacking
Due to modern mass production techniques, it is unlikely that your chain saw is
faulty or that a part is missing. If you find anything wrong, do not operate the
tool until the parts have been replaced or the fault has been rectified. Failure to
do so could result in serious personal injury.
Fitting the bucking spikes
Fit the bucking spikes as shown using
the two cross-headed screws provided. (Fig A)
Installing the guide bar and chain
WARNING. The chain has sharp edges.
Use work gloves for safety.
IMPORTANT. Front guard (chain brake) must be disengaged
when installing the guide bar and chain.
1.
Pull the front guard (7) towards the rear of the saw until
there is a “click” to make sure that the chain brake is released. (Fig B)
2. Remove the chain cover by: -
a) Removing the chain drive cover nut. (Fig C)
b) Removing the rear side cover locking knob. (Fig D)
c) Removing the side cover. (Fig E)
3. Fully loosen the chain tensioning screw
(3) by turning in an anti-clockwise direction. (Fig F)
4. Place the guide bar (1) in position over the threaded stud
and locate on the two guide pins. Slide the guide bar fully
towards the sprocket of the saw. (Fig G)
A
B
C
D E F G
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline PCH25 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline PCH25 in the language / languages: English as an attachment in your email.

The manual is 2,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info