724679
11
Zoom out
Zoom in
Previous page
1/24
Next page
S U A 1800 909 909 www.globalpowerbrands.com email: help@globalpowerbrands.com
AFTER SALES SUPPORT 43669
11
Assembly
Preparation of the blower vac prior to use
The petrol blower vac requires some assembly prior to use. This includes joining
of the vac tubes, joining of the blower tubes, and depending if the tool is to be
used for blowing or vac, fitting of the tube assembly to the housing and fitting
the collection bag assembly to the housing. A medium size phillips screw driver is
required to make the above assemblies.
Setting up for use as a blower.
IMPORTANT. Blower tube installation affects both blower balance and
performance. Both tube and nozzle must be screwed together.
WARNING. Danger from rotating impeller!
Stop the engine before installing or removing the blower tubes. Never perform
any maintenance or assembly procedures on this machine while the engine is
running.
Attaching the blower tube
1. Place the blower upright on the ground
or on a sturdy work surface.
2. Push the blower tube nozzle tube (5) over
the lower blow tube (4), lining up the
locking pins.
3. Rotate the blow tube nozzle clockwise on
the lower blow tube locking it into place.
4. Lock the tubes together using the 2
screws provided.
5. Align and then push the assembled
blower tube assembly over the discharge
port on the blower outlet and rotate until
locks in place and the screw hole can
be seen.
Getting Started 4
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline PBV26CC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline PBV26CC in the language / languages: English as an attachment in your email.

The manual is 1,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info