724639
13
Zoom out
Zoom in
Previous page
1/16
Next page
26cc 2-Stroke Hedge Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. MQE-3SPK-560 • 43671 • 09/2018
(toll free)
AFTER SALES SUPPORT
(toll free)
26cc 2-Stroke Hedge Trimmer
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. MQE-3SPK-560 • 43671 • 09/2018
22 23
Maintenance Maintenance
Storage and Maintenance after use
1. Perform all the general maintenance recommended in the Maintenance
Section of your Instruction Manual.
2. Clean the outside surfaces of the hedge trimmer.
3. Check the fuel system for any leaks.
4. Drain the fuel from the fuel tank (12). Note. Do not discard unwanted fuel
with household waste. It must be taken to an authorised repository site.
NOTE. Draining the fuel tank should be done outdoors.
5. After the fuel is drained, start the engine.
6. Run the engine at idle until the unit stops. This will clear the carburettor
of fuel.
7. Allow the engine to cool (approx. 5 minutes).
8. Using the supplied spark plug spanner / combination screwdriver (23),
remove the spark plug (6).
9. Pour 1 teaspoon of clean 2-stroke oil into the combustion chamber. Pull
the recoil starter (8) slowly several times to coat the internal components.
Replace spark plug (6).
10. Store the unit in a cool, dry place away from any source of ignition such as
an oil burner, water heater, etc.
11. If disposing of the unit, recycle the unwanted materials instead of disposing
of them as waste. All tools, hoses and packaging should be sorted, taken to
the local recycling centre and disposed of in an environmentally safe way.
12. Check the operation of the on/o switch (10) controls prior to use or during
maintenance check. (refer to service centre if not operating correctly)
13. Check the condition of the blade for sharpness, cutting edge damage and
binding/ jamming of the blades prior to use or during maintenance check.
14. Check the clutch operation. With motor at idle, blades must not operate
and should only engage when motor is accelerated and stop when the
motor is slowed to idle prior to use or during maintenance check.
Removing a unit from storage
1. Remove spark plug (6).
2. Pull the recoil starter (8) briskly to clear excess oil
from the combustion chamber.
3. Clean and gap the spark plug (6) or install a new
spark plug with the proper gap. (Fig 9)
4. Prepare the unit for operation.
5. Fill the fuel tank (12) with the proper fuel / oil mixture.
See Preparation Section.
Service Support
If you have any issues with the operation of your product, please take it with a
copy of your receipt to one of our National Service Agents for repair.
A listing of our Service Agents is included with your product, however, you can
also nd our most updated listing by visiting https://help.tools/ and clicking on
the Service Agent link.
Accesories and After Sales Parts
Should you nd the spark plug or other consumables becomes worn
or past its user life, replacements can be purchased online via our
website https://help.tools/
If you have any queries regarding accessories, please call us on our
Customer Support Line - 1800 909 909.
2. Spark Plug
(Torch L9T)
2. Recoil Starter
(43671-SPRS)
3. Air Filter (43671-SPAF)
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline MQE-3SPK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline MQE-3SPK in the language / languages: English as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info