724678

Gardenline LT26 Manual

11
Zoom out
Zoom in
Previous page
1/24
Next page
S U A 1800 909 909 www.globalpowerbrands.com email: help@globalpowerbrands.com
AFTER SALES SUPPORT 43670
11
2. Place the hex nut into the hex shape recess
on the guard. Slide the screw through the
side of the safety guard and tighten with
the hex key provided.
Joining the shaft
1. Depress the location pin and insert the
lower shaft (5b) into the upper shaft (5a).
Rotate the lower shaft until the pin locates
positively into the hole in the upper shaft.
2. Tighten the shaft locking knob (21) to
secure both shafts in place.
Fitting the spool
Note. The spool assembly is contained
with shrink plastic to assist in the assembly.
Keep this plastic wrap intact while you assemble. When fitting
the spool on the shaft, the shaft will pierce through the thin
plastic wrap.
1. Slide the raised section of the spool (1) onto the end of the
shaft. Ensure the large hex recess on the rear of the spool fits
fully over the large hex drive on the base of the spindle.
2. With your fingers, push the spool fully into the housing and
screw the bump knob (18) onto the end of the shaft by turning
it in a clockwise direction. Screw the bump knob onto the
shaft until it’s tight whilst holding the spool.
Note. Ensure to remove any packing tape and plastic wrap
from the spool at this stage.
3. Once the spool is fully inserted and the lines are fully through
the eyelets, pull firmly on each line to disengage the lines from the spool notches.
Ensure the lines are fully clear of the spool notches and the line is passing through
the eyelets directly to the spool.
Note. If you require replacement spool and line, this is available for purchase.
Please refer to page 23 for further detail.
5
Instructions
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline LT26 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline LT26 in the language / languages: English as an attachment in your email.

The manual is 1,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info