820996

Gardena AquaContour automatic - 8133 Manual

17
Zoom out
Zoom in
Previous page
1/70
Next page
 6. MAINTENANCE
6.1 Replace batteries [ Fig. M1 ]:
If the Set LED 1 and Set LED 2 start flashing
every 8 seconds, the batteries have to be
replaced.
The programmes remain unchanged.
1. Turn the battery cover e on the bottom of the
Large-Area Irrigation AquaContour automatic
anticlockwise 1 and pull out carefully 2 (bayonet
coupling).
2. Remove battery holder r and insert 4 batteries
(1.5 V round cells type IEC LR14).
When doing so, ensure correct polarity + / −.
3. Re-insert battery holder r.
4. Fit battery cover e in reverse order.
6.1.1 Test battery:
The batteries must be tested after each
irrigation!
If no irrigation or programming is being made, the
sprinkler goes into “sleep mode” (the green Auto-
LED 6 does not light up and the red Set-LED
blinks every 8 seconds).
v During “sleep mode” (the green Auto LED 6
does not light up) press the two buttons “+”
button 2 and “−” button 3 for 4 seconds.
Both green Auto LEDs light up:
batteries have still enough capacity.
Both red Auto LEDs are blinking:
exchange batteries.
6.2 Clean dirt filter [ Fig. M2 ]:
1. Turn the dirt filter t anticlockwise 1 and pull out
carefully 2 (bayonet coupling).
2. Clean dirt filter t under clean running water.
3. Refit dirt filter t in reverse order.
6.3 Clean nozzles [ Fig. M3 / M4 ]:
If the watering pattern is no longer even, the
nozzles can be cleaned using the cleaning
needle provided. The cleaning needle is located
on the bottom of the housing.
1. Turn the cleaning needle z (e. g. with a coin)
anticlockwise through 180° and pull out carefully
(bayonet coupling).
2. Clean nozzles u with cleaning needle z.
3. Refit cleaning needle z in reverse order.
 7. TROUBLESHOOTING
7.1 Troubleshooting table:
Problem Possible Cause Remedy
Irrigation width smaller than
on initial start-up Dirt filter soiled. v Clean dirt filter.
Tap not opened sufficiently. v Open tap further.
Water pressure too low. v Increase water pressure /
water supply.
Batteries are flat. v Replace batteries. If the bat-
teries are flat, the range is
reduced to the minimum level.
Irrigation range is programmed
incorrectly.
v Reprogramme irrigation range.
Watering pattern uneven Nozzles soiled. v Clean nozzles.
Nozzle head soiled. v Clean nozzle head.
Nozzle head damaged. v Contact GARDENA Service.
 5. STORAGE
1. Remove batteries from the Large-Area Irrigation
AquaContour automatic.
The programmes remain unchanged.
2. Store the Large-Area Irrigation AquaContour
automatic in a dry place protected from frost.
Information about programming:
As soon as the first point is programmed, any
existing programme will be deleted. After pro-
gramming has been completed, no further
points can be deleted or added later on. If the
contour has not been set as required, repro-
gramming with more points will have to be car-
ried out. If no button is pressed for 60 seconds
during programming, programming will be auto-
matically ended and the contour stored.
4.3 Start / end watering [ Fig. F1 ]:
Before irrigation can be started, the Large-
Area Irrigation AquaContour automatic
must have been programmed.
1. Fit the Large-Area Irrigation AquaContour
automatic onto one of the two ground markers
with the 2 spikes (see 3. Initial Operation
lnstall ground marker in ground).
2. Select sector stops according to location
(see 4. OPERATION Select watering sector).
3. Press OK button 4.
The green Auto LED 6 lights up.
4. Select programme: Keep pressing Menu but-
ton1 until the required green Auto LED 6
(1 or 2) lights up.
The required programme 1 or 2 has been
selected.
4.3.1 Start watering:
v Fully open water supply.
Watering will start automatically and the contour
of the selected watering sector will be watered.
4.3.2 End watering:
v Close water supply.
Watering will end. The programme remains
unchanged.
en
17
GAR_08133-20.960.11_2024-06-05.indb 17GAR_08133-20.960.11_2024-06-05.indb 17 05.06.24 11:2005.06.24 11:20
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardena AquaContour automatic - 8133 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardena AquaContour automatic - 8133 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 3.26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info