544803
14
Zoom out
Zoom in
Previous page
1/78
Next page
ENGLISH
• 12 •
NOTE: It may happen that the self-priming feature of the
pump fails to work temporarily due to an air lock.
In this case water does not fl ow from brewing head (14), and
the following procedure should be followed:
a) Place a small frothing pitcher or mug under the steam
nozzle (8).
b) Turn the steam knob (7) counter-clockwise to open the
steam/hot water valve, and turn the steam switch (4)
and the hot water/brew (2) to “On to activate the
pump.
c) Alter a few seconds, a steady stream of water will emerge
from the steam nozzle.Allow about one cup of water to
ll the pitcher. Shut the steam/hot water valve and turn
hot water/brew switch and the steam switch (4) to
“Off.
d) NOTE: The temperature ready-light (5) will automatically
ash as the machine boiler heats.
After switching on the machine for the fi rst coffee, wait 6
minutes until the machine has fully heated up, while for
all subsequent coffees the machine will be ready to use.
Another feature of the machine is the “no-drip system”,
eliminating most of dripping from brewing head (14). After
coffee brewing, however, a little dripping may occur due to
wet coffee grinds in the fi lter-holder.
Using the machine for the fi rst time or
after a period of inactivity
This simple operation ensures an optimum brewing and must
be performed:
- at fi rst start-up;
- when the machine remains inactive for a long time (more
than 2 weeks).
NOTE: Dispensed water must be emptied into an adequate
drain. It is not suitable for food use. If the container fi lls
up, stop dispensing water during the cycle and empty it
before resuming the operation.
A (Fig.02) - Rinse the tank and fi ll it again with fresh
drinking water.
B (Fig.03) - Place a container under the steam wand
(Pannarello). Open the knob (7) slowly by turning it
clockwise. Press the hot water/brew button (2) and
steam button (4).
C Dispense the whole water tank from the steam/hot
water wand. To stop dispensing, press the hot water/
brew button (2) and the steam button (4) again. Then
close the knob (7) by turning it counter-clockwise.
D (Fig.02) - Fill the water tank with fresh drinking
water.
E Insert the fi lter holder into the brew unit from the bottom
(14) and turn it from left to right until it locks into
place.
F Place a suitable container under the fi lter holder.
G Press the brew button (2) and dispense all the water in
the water tank. Once the tank is empty, stop dispensing
by pressing the brew button again (2). At the end, empty
the container.
H Remove the fi lter holder from the unit by turning it from
right to left and rinse it with fresh drinking water.
I The machine is now ready to be used.
For further information on how to dispense hot water, please
refer to sections "How to brew a good Espresso
Coffee" and "Making Hot Water".
Caution: Never operate pump without water
in machine as damage to the pump may occur.
Damage of pump run without water is not covered
by warranty.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gaggia RI9301 Gaggia Baby at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gaggia RI9301 Gaggia Baby in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info