566460
10
Zoom out
Zoom in
Previous page
1/94
Next page
10
Fasten about 5-10cm
from the servo outlet
so that the lead wire
is neat.
Margin in the lead wire.
To prevent the servo lead wires from being broken by vibration
during flight, provide a bit of slack so that the wire is not
pulling against the servo or connector going to the receiver. In

IMPORTANT: In order to maximize the performance and enjoyment of the Futaba T6J transmitter, please
read this section carefully and completely.
Receiver Installation:
In order to obtain the best possible performance from your 2.4GHz aircraft receiver, we have developed the
following guidelines and suggestions.
Antenna
*Must be kept as straight as possible.
Coaxial cable
The R2006GS has two antennas. In order to
maximize signal reception and promote safe
modeling Futaba has adopted a diversity antenna
system. This allows the receiver to obtain RF

To obtain the best results from the diversity function, please refer to the following instructions:
The two antennas must be kept as straight as possible. Failure to
do so might result in reduced operational range of the model.
Ideally, the two antennas should be placed at 90 degrees to each
other. However, the most critical aspect is to keep the antennas
away from each other as much as possible.
Larger models can have large metal objects that can attenuate the
RF signal. In this case the antennas should be placed at both sides of the model. Then the best RF signal

The antennas should be kept away from conductive materials, such as metal and carbon by at least half-
inch. The coaxial part of the antennas does not need to follow these guidelines, but do not bend in a small
radius.
Antenna Antenna
10


Need help? Post your question in this forum.

Forumrules
1

Forum

futaba-t6j---2.4ghz

Reset search

  • Sorry my bad english, did you have the manual in spanish? Submitted on 6-10-2021 at 05:09

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba T6J - 2.4GHz at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba T6J - 2.4GHz in the language / languages: English as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info