450995
56
Zoom out
Zoom in
Previous page
1/119
Next page
56
Aircraft tail types (
ACRO
GLID
):
There are 4 basic tail types in aircraft models:
Simple. Model uses one elevator servo and one rudder servo (or multiple servos on a Y-harness). This is the default.
Dual Elevator servos. Model uses 2 elevator servos. see
AILVATOR
(
ACRO
) see p. 57.
Tail-less model. Model uses 2 wing servos together to create roll and pitch control. see
ELEVON
(
ACRO
GLID 1A+1F
). see p. 56.
V-TAIL
. Model uses 2 surfaces, at an angle, together to create yaw and pitch control. see
V-TAIL
(
ACRO
GLID
). see p. 58.
Note: Only one of the three tail-type functions (
AILEVATOR
,
V-TAIL
, and
ELEVON
) can be used at a time. The radio provides a
ZDUQLQJDQGZLOOQRWDOORZWKHDFWLYDWLRQRIDQRWKHUWDLOW\SHXQWLOWKH¿UVWLVGHDFWLYDWHG$QHUURUPHVVDJHRI
OTHER WING
MIXING IS ON
will display. (See the wing type example on page 51.)
Using
ELEVON
(
ACRO
GLID 1A+1F
XVHGZLWKGHOWDZLQJVÀ\LQJZLQJVDQGRWKHUWDLOOHVVDLUFUDIWWKDWFRPELQHDLOHURQDQG
HOHYDWRUIXQFWLRQV XVLQJ WZRVHUYRV RQHRQ HDFK HOHYRQ7KH DLOHURQHOHYDWRUUHVSRQVHV RIHDFK VHUYR FDQEH DGMXVWHG
independently. This is also popular for ground model use, such as tanks, which drive two motors together for forward, and
RQHPRWRUIRUZDUGRQHEDFNZDUGIRUWXUQLQJ
Adjustability:
Requires use of CH1 and CH2.
Independently adjustable aileron travel allows aileron differential.
Independently adjustable elevator travel allows for differences in up vs. down
travel.
Separate
ELEVON
settings for each condition (
GLID
only)
[Note] When changing the polarity (positive or negative) of a rate, "change rate
dir?" is displayed as a check. Please set up after pressing DIAL for 1 second and
canceling the alarm display. (
GLID
only)
NOTE: If
ELEVON
is active, you cannot activate
FLAPERON
,
AILE-DIFF
, or
AILEVATOR
. An error message
OTHER WING MIXING IS ON
displays and you must
deactivate the last function to activate
ELEVON
.
127(%HVXUHWRPRYHWKHHOHYDWRUDQGDLOHURQVWLFNVWRIXOOGHÀHFWLRQGXULQJ
setup. If large travels are specified, when the AILERON and ELEVATOR
STICKS are moved at the same time the controls may bind or run out of travel.
(
For details on setting up a complex aerobatic plane, please visit www.futaba-
rc.com\faq\. Many other setup examples are also available at this location.
)
GOAL of EXAMPLE: STEPS: INPUTS:
Activate
ELEVON
.
Adjust aileron down travel to
90%
of up
travel, creating aileron differential.
Open the
ELEVON
function.
for 1 second.
(If
BASIC
, again.)
C
to
ELEVON
.
Activate the function.
C
to
MIX
. to
ACT
.
Optional: adjust the up/down travel
separately for the servos as ailerons.
(Ex: down to
90%
.)
C
to
AIL1
. AILERON STICK.
to
90%
.
C
to
AIL2
. AILERON STICK.
to
90%
.
Optional: adjust the elevator travel of
each servo. (Ex: right servo elev. travel
to
98%
, left to
105%
.)
C
to
ELE2
. to
98%
.
C
to
ELE1
. to
105%
.
Close menu.
Where next? Adjust individual servo's
SUB-TRIMs
: see p. 49 and
END POINTs
: see p. 39.
6HWXSGXDOWULSOHUDWHVDQGH[SRQHQWLDO
D/R
,
EXP
): see p. 42.
View additional model setups on the internet: www.futaba-rc.com\faq.html
(GLID 1A+1F)
(ACRO)
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba T10 CAG at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba T10 CAG in the language / languages: English as an attachment in your email.

The manual is 2,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info