747917
196
Zoom out
Zoom in
Previous page
1/228
Next page
196
GO to TABLE OF CONTENTS
RudderExpertRudderExpert
(6) F/F.Rate U / F/F.Rate D: F/F mixing rate
Feed Forward mix is used to counteract sudden increases in torque from the
motor during fast collective pitch changes. If you notice a tail kick, using (right
rudder on Clockwise rotor disk, left rudder on CCW) F/F mixing can be tuned
to reduce the tail kick. The mixing amount can be individually set for high pitch
side (U) and low pitch (D) side with zero pitch as the center.
Settingranges:-100~0~+100%Initialvalue:+0%
(7) ACC Gain: F/F mixing acceleration gain
In low head speed situations where a lot of F/F Mixing might be needed,
acc. gain boosts the input and removes it immediately after to help cure the
sudden change in torque, but it does not allow the large tail rotor input to
alter the axial behavior of the helicopter.
Settingranges:0~200%Initialvalue:0%
(8) Tail Resp: Tail response
The goal is to match the response between the helicopter tail response and the
gyro control. This feature is utilized to do so. 1 is the fastest response. Gener-
ally, if the tail response is slow or the servo's speed is slow, setting the tail
response setting late will increase the gyro sensitivity and improve the control
performance. Also, if the response setting is delayed, the power consumption of
the servo will be reduced. However, if the response setting is too late, the opera-
tion cannot keep up with high-speed operation of the helicopter.
Settingranges:1~5Initialvalue:1
(9) RESET : Rudder gyro data reset
This resets the "Rudder Expert" setting back to the defaults.
196


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba T-16IZ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba T-16IZ in the language / languages: English as an attachment in your email.

The manual is 35,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info