747922
41
Zoom out
Zoom in
Previous page
1/183
Next page
41
Basic Operation
*If there are many FASSTest (T-FHSS) systems
turned on around your receiver, it might not
link to your transmitter. In this case, even if the
receiver's LED stays solid green, unfortunately
the receiver might have established a link
to one of other transmitters. This is very
dangerous if you do not notice this situation.
In order to avoid the problem, we strongly
recommend you to double check whether
your receiver is really under control by your
transmitter by giving the stick input and then
checking the servo response.
*Do not perform the linking operation when
the drive motor is connected or the engine is
running.
*When you use two receivers, please be sure to
setup a "Rx1" and "Rx2" in the "dual" mode.
10. When a telemetry function is enabled,
the receiving interval (down-link interval)
of sensor data can be changed. If a D/
L interval is increased, the response of the
sensor data display becomes slower, but
stick response will improve.
Initial value: 1.0s
Adjustment range: 0.1s~2.0s
9. ACT will be chosen if telemetry is used.
It is INH when not using it.
After setting, press a H/E button
*Telemetry function cannot be used for the 2nd
receiver.
FASSTest18CH
*Telemetry function cannot be used for the dual
receiver.
T-FHSS, FASSTest12CH
*You must link one receiver at a time. If both
power supplies to the receivers are switched on
simultaneously, data is received incorrectly by
the transmitter.
*You cannot link three receivers.
*Link is required when a system type is
changed.
*Linking is required whenever a new model is
made.
WARNING
After the linking is done, please cycle
receiver power and check that the
receiver to be linked is really under the
control of the transmitter.
Do not perform the linking procedure
with motor's main wire connected or
with the engine operating as it may
result in serious injury.
ŤƉƗƈƕŃƖƈƗƗƌƑƊ
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FX36 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FX36 in the language / languages: English as an attachment in your email.

The manual is 11,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Futaba FX36

Futaba FX36 User Manual - German - 61 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info