Manual Futaba FP8SSHP (page 18 of 36) (English)

30098

Zoom out

Zoom in

1/36

Rudder servo

Settable within

this range by

trimmer [16] .

Fig. 41

17. This trimmer sets the

rudder servo throw and

direction when the rudder

button [33] is set to ON

(pressed). The servo throw

can be adjusted up to the

total travel.

18. Rudder time trimmer

This trimmer

sets

the

time

the rudder servo stops at a

fixed deflection when the

rudder button [33] is pres-

sed. A time from 0 to

about 3 seconds can be set.

19. Rudder button fail safe

switch

When this switch is set to

the RUD.REV position,

the rudder button oper-

ates. When it is set to the

INH side, the rudder but-

ton becomes inoperative.

Fig.

20. Rudder dual

rate

trimmer

This trimmer adjusts the

rudder servo throw when

the

rudder dual rate switch

[16]

set

to ON. It

has

the

same functions as the ailer-

on dual rate trimmer [1]

described on page 13.

221 LINEAR <->VTR switch.

This switch has the same

functions as the aileron

LINEAR <-> VTR switch

described on page 13.

22. Revolution

[17 ]

and

[18 ]

and

acceleration

mixing

trimmer [15] direction switching and function OFF

switch

•When the main rotor turns clockwise, set this switch

to the R position. If the main rotor rotates counter-

clockwise, set this switch to the L position. (The

linkage may also be reversed.)

•When the switch is set to the

center position, the

revolution

[17]

and [18]

and acceleration [15] functions

are

turned off.

E. Elevator

23. Elevator dual rate trimmer

This trimmer adjusts the elevator servo throw when

the elevator dual rate switch [15] is set to ON. It has

the same functions as the aileron dual rate trimmer

[1] described on page 13.

24. LINEAR <-> VTR

This switch has the same

functions as the aileron

LINEAR <-> VTR switch

[2]

described on page 13.

25. This switch is used to select

aileron dual rate and eleva-

tor dual rate simultaneous

ON-OFF or separate ON-

OFF.

• When this switch is set to the

lower position, the aileron

dual rate switch [14] and

elevator dual rate switch

[15]

can be turned on and off

separately.

•When this switch is set

the COMB position, the

aileron and elevator dual

rates can be turned on and

off simultaneously with the

aileron dual rate switch

[14].

Set it to the position you

like best.

Fig.

2nd

ATV

ATV is the abbreviation of Adjustable Travel Volume.

It is a device which allows independent adjustment of

the servo left and right (up and down) throw without

affecting the neutral position. Because of the engine

torque, precision of the model, and for other reasons,

the radius of left and right turns is always different

even if the left and right steering throws are perfectly

matched. The ATV is most convenient when left turns

are good, but right turns are to sharp. In this case, left

and right turns of the same radius can be easily made

by reducing the servo right throw slightly. The aileron

and elevator 2nd ATV is the conventional trimmer

type ATV.

Aileron [26]

right

Aileron [27]

left

[28 Elevator

[291

Elevator

down

Fig.

When the ATV trimmer is turned clockwise,

the throw increases. When it is turned counter-

clockwise, the throw decreases.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP8SSHP in the language / languages: English as an attachment in your email.

The manual is 1,96 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Futaba FP8SSHP Manual

Product: