30072

Futaba FP6FN Manual

15
Zoom out
Zoom in
Previous page
1/20
Next page
1. The cord with the power plug at both ends is the Tx charging use cord. To charge the transmitter, connect
this cord to Tx of the charger and "A" of the transmitter.
2. The cord with the power plug at one end and the 3P connector at the other end is the RX charging use cord.
When charging the NR-4C receiver use nickel-cadmium battery, connect the power plug end of this cord to
RX of the charger and the 3P connector end to the NR-4C.
3. Plug the charger plug into an AC line receptacle (AC 115V, 220V, 240V).
4. Charging is performed with the above operations. At this time, the LED of the charger will be illuminated to
indicate that charging is being performed.
5. Be absolutely sure that all the connections are correct. If the NR-4C receiver use nickel-cadmium battery is
connected to Tx, the battery may be damaged by overcharging.
6. The special charger can charge the transmitter battery and receiver battery simultaneously or independently.
PERFORMANCE TEST AND MOUNTING PRECAUTIONS
1. Verify that the receiver and servos are connected in accordance with Figure 3. Then, make the transmitter
antenna
as
short
as
possible and
extend
the receiver antenna and attempt operation
from
a
distance of
20m~
30m. Operation is normal if all the controls are functioning properly. Perform this test within a maximum of
5 minutes time. Never perform this test when the transmitter antenna is not mounted to the transmitter. Other-
wise the transmitter will be adversely effected.
2. Be careful that the receiver does not directly touch other mechanisms of the aircraft itself. Moreover, wrap the
receiver in sponge rubber so that it is not subjected directly to engine vibrations. (In the case of boat use, cover
the sponge wrapping with a vinyl bag and tie securely at the point at which the cord enters so that no water can
enter the receiver.)
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP6FN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP6FN in the language / languages: English as an attachment in your email.

The manual is 1,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info