29992
13
Zoom out
Zoom in
Previous page
1/20
Next page
NICKEL-CADMIUM BATTERY AND CHARGING METHODS
The FP-T3FN, FP-T4FN, FP-T5FN, and FP-T6FN transmitters are each equipped with a built-in nickel-cadmium
battery (8/450 mAH) power supply.
Use a nickel-cadmium penlight cell (4/450mAH) as the receiver and servo power supply.
Charge the nickel-cadmium battery for 12~15 hours before normal use. Charge the battery for 20 hours when
it has not be used for an extended period of time. Slight overcharging will cause no harm to the battery.
A fully charged nickel-cadmium battery can normally be used about 10 times at a 10 minutes/time rate.
The nickel-cadmium battery will supply a uniform voltage for a certain period of time, but pay careful attention
to the voltage after being used 7~8 times.
Connect the battery charger supplied with the FP-3FN, FP-4FN, FP-5FN, and FP-6FN as illustrated in Figure 5.
Fig.
5
AC-115V (220V, 240
FBC-2 (F)
Tx
Rx
NR-4C
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP3FN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP3FN in the language / languages: English as an attachment in your email.

The manual is 1,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info