29992

Futaba FP3FN Manual

11
Zoom out
Zoom in
Previous page
1/20
Next page
FUTABA TRAINER SYSTEM
•The
NEW FUTABA PROPORTIONAL
Transmitters
FP-T4FN.
FP-T5FN,
and
FP-T6FN
are
equipped
with
the
newly developed FUTABA Trainer System as standard. This system prevents damaging of valuable aircraft by
beginners. Use this system with a veteran as your teacher. A special trainer cord is available as an option.
• The FUTABA Trainer System can be used without regard to frequency (27MHz, 40MHz, 72MHz) or number of
channels of the instructor's transmitter and students transmitter. For instance, the 27MHz FP-T6FN can be
used with the 72 MHz FP-T4FN. However, in this case, use the 27MHz FP-T6FN as the instructor's trans-
mitter if the frequency of the receiver is 27MHz and use the 72MHz FP-T4FN as the instructor's transmitter if
the frequency of the receiver is 72MHz. Naturally, the number of operable channels corresponds to that of the
transmitter. The above is an example of 4 channel operation.
OPERATING INSTRUCTIONS
1. When conducting training, connect the two transmitters together with the special cord*as illustrated in Figure 4.
*Similar cords are on sale, but since these cannot be used, always use the special FUTABA shielded trainer
cord.
2. The instructor must use a transmitter of the same band as the receiver. (The instructor's transmitter is desig-
nated
Tx1 and the student's transmitter is designated Tx2.)
Since the radio waves are always radiated from the Tx1 side (transmitter whose power has been turned on),
extend the antenna of Tx1 fully. The position of the antenna of Tx2 doesn't matter, since the radio waves are
radiated from Tx1 even when operation is performed from Tx2.
3. Turn on the power of Tx1 only. The meter pointer will deflect, the same as for the case of independent operation.
The meter pointer of Tx2 will also deflect simultaneously.
NOTE: Never turn the power switch of Tx2 on, regardless of whether the bands coincide or not.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP3FN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP3FN in the language / languages: English as an attachment in your email.

The manual is 1,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info