29023

Futaba ATTACK_SPORT Manual

2
Zoom out
Zoom in
Previous page
1/8
Next page
The ATTACK-SPORT has a BEC function
• The BEC (Battery Eliminator Circuitry) system is a high performance constant voltage
circuit (regulator). Since the running Nicd battery can also be used as the receiver servo
power supply, there is no troublesome wiring and the vehicle can be made lighter.
• Transmitter is Built-in servo reverse switches. (FP-2NCR)
TRANSMITTER FP-T2NCS/T2NCR
SERVO FP-S148
RUGGED, LOW-PROFILE SERVO
•Racing specification short aluminum stick lever makes
operation extremely easy.
•The
stick
can
be
changed
to
a
ratchet
system
by
installing an optional slider.
• Servo reverse switches (steering & throttle).
Since each servo can be switched between forward
and
reverse from the outside of the transmitter, linkage
hookup is extremely easy. (T2NCR)
• Level meter shows the state of the battery at a glance.
•Crystal can be changed from the outside. (Except 72/
75 MHz
in
USA)
RECEIVER FP-R102JE
•Miniature and lightweight high-performance AM
2CH
receiver with built-in BEC is realized by using chip parts.
(20% smaller and 35% lighter than our R102GF.)
• Intermodulation interference characteristic improved
substantially by using a new circuit system AIC circuit.
•Reliability is improved further by using the unique
Futaba custom decoder 1C.
• Newly designed case is small and easy-to-use.
• High sensitivity design by built-in RF amp.
•High-performance built-in BEC system can handle
power supply voltages up to 8.4 V.
•The
PP-S148
is
a
low 1.4
inches
high and
has
a
thin
design that can be easily mounted in all models.
•Vibration
and
shock
resistance
have
been
improved
further by using a direct wiring system which directly
connects the servo amp, motor and potentiometer.
•The
height of
the
servo
has
been
reduced
and high
torque, high speed, and smooth movement equal to that
of the coreless servo have been realized by using a new
small, high-performance motor. (Output torque 42
oz-in <3kg, cm), operating speed 0.22 sec/60°).
• New indirect drive/completely sealed potentiometer
substantially improves vibration
and shock resistance,
and neutral accuracy.
•Unique Futaba power-saving custom 1C provides high
starting torque narrow dead band, and excellent track-
ability.
•Fiberglass P8T (polybutylene terephthalate) servo case
is mechanically strong and is invulnerable to glow fuel.
•Strong
polyacetyl
resin
precision
servo
gear
featuring
smooth operation, accurate neutral, and minimal back-
lash.
•Fiberglass epoxy PC board with THRU-THE-HOLE
plating improves the servo amp vibration and shock
resistance.
•Thick plated connector pins eliminate the problem
of
faulty contact, improve reliability against shock
and
vibration, and prevent reverse insertion.
•Special pad grommets simplify mounting
of the servo,
and are extremely vibration-resistant.
•Six kind of special adjustable horns are available.
•High
42
oz-in
(3kg-cm)
output
torque
is
perfect
for
almost all models.
Transmitter
Receiver
Servo
Others
FP-2NCS
FP-T2NCS x 1
FP-R102JE x 1
FP-S148x 2
Switch, frequency flag, etc.
FP-2NCR
FP-T2NCR x 1
FP-R102JE x 1
FP-S148 x 2
Specifications are subject to
change without prior notice.
Transmitter FP.T2NCS/T2NCR
Operating system
Transmitting
frequency
Modulation
Power requirement
Current drain
2 stick
27MHz bands 1 to 6.72, 75MHz
AM (Amplitude Modulation)
12 0V. penlight battery x 8
170mA
Receiving
frequency
Intermediate
frequency
Power requirement
Current drain
Dimensions
Weight
Range
Receiver—
FP-R102JE
27 MHz and 72/75 MHz band
455 kHz
4.8
V
to
8.4
V
(BEC
built-in)
8.4V/12mA,4.8V/33mA
(no signal)
1.23x 1.87
x
0.78
in
133x47.4 x 19.8mm)
0.88
oz
125
g)
300 m on the ground with
FP-T2NCS T2NCR
(At the best radio wave condition
of environment) -
SERVO FP-S148
Control system
Operating angle
Powar
requirement
Current drain
(IDLE)
Output torques
Operating sp—ed
Dimensions
Weight
+pulse width control
One side 45° or more
4.8V-6V
6.0V, 8mA (at idle)
42 oz.
in.
(3
kg
cm)
0.22 sec/60°
1 .59x0.77 x 1.4 in.
(40.4
x
19.8
x
36
mm)
1.5 oz.(44.4g)
1
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba ATTACK_SPORT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba ATTACK_SPORT in the language / languages: English as an attachment in your email.

The manual is 1,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info