29011
71
Zoom out
Zoom in
Previous page
1/78
Next page
Common Condition Section
TRIM OFFSET
(TOF)
The Trim Offset function may be used to set a
trim offset for different flight conditions. For
Helicopters, this is very useful to set offsets when
the Pitch -> rudder (P->R) mixing is used. For Sail-
planes, it may be used for setting trims for both
elevator (ETM) and full wing camber, which may
be programmed within Trim mixes 1 and 2 (TM1,
TM2).
You may set a time delay to slow down the
servo motions when the flight condition is switch-
ed.
The
delay
should
be
entered
in
the
digital
trim
TRM function (page 71).
Mode Setting
Trim Offset Value
Trim Selection
Keys
Return To
Condition Menu
Mode Selection Keys
Using
the
Trim
Offset
Command
Activation of command
In the Condition Menu, press the
•TOF ke
y to get the
TRM OFFSET menu shown below.
Press the
A
key to get the activation menu. You may
activate the Trim Offset function by pressing the ACT
F key; to deactivate the function, press the INH G
key.
Trim Position Selection (T1 to T4)
Select the trim to be set with the
O to R
keys. The
displayed trims T1 to T4 are the channels set by the func-
tion change (FNC) menu. Initially, the display should
show T1 (trim 1): Aileron; T2 (trim 2): Throttle; T3
(trim 3): Elevator; T4 (trim 4); Rudder. Note that when a
trim is set to ATL type (throttle, for example), the offset
rate cannot be set.
Offset Rate setting
Set
the trim
offset
with
the rate setting
keys
EtoM
.
Initial values are set to 0%, but may range between —100
and +100%. Repeat these steps for each trim.
End setting by pressing the END N key.
Common Conditions Section, Page 69
71


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 9ZHP_part1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 9ZHP_part1 in the language / languages: English as an attachment in your email.

The manual is 3,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info