29011
70
Zoom out
Zoom in
Previous page
1/78
Next page
Common Condition Section
SUBTRIM (STM)—SERVO NEUTRAL ADJUSTMEMT
The Subtrim function is used to set the servo
neutral position, and may be used to make fine
adjustments of control surface neutrals as linkages
and pushrods are hooked up. When you begin to
set
up
a
model,
be sure
that
the
digital
trims
are
set to their center position (page 71).
Value of
Subtrim
Return To
Condition Menu
Setting
Position
Channel Selection Keys
Using the Subtrim Command
Activation of command
In
the Condition Menu, press the
STM key to get the
SUB TRIM menu shown below.
Subtrim Channel selection
Press the key corresponding to the channel to be
selected, using the
F to M
keys. Next, you input the
subtrim position with the rate setting keys
E to M
Initially all subtrims are set to a 0% value, but actual
settings may range from —120 to +120%. You should try
to adjust your linkage so that the subtrims are near zero
for all surfaces and linkages.
Repeat this procedure for each control on the model.
End by pressing the END N key.
Common Conditions Section, Page 68
70


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 9ZHP_part1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 9ZHP_part1 in the language / languages: English as an attachment in your email.

The manual is 3,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info