29011
30
Zoom out
Zoom in
Previous page
1/78
Next page
System Section
SRV—SERVO CYCLE & BAR GRAPH DISPLAY
This key has two different functions: a servo
cycling mode, which slowly moves each servo to
its extreme positions, and a servo bar graph indi-
cation, which pictorially shows the position to
which each servo is being commanded. The servo
test function is useful for finding unevenness in
servos, and the bar graph function may be used for
roughly setting up models without using a receiver
or servos. This can be particularly handy in setting
up models with complicated mixing functions,
because the results of each stick, lever, knob,
switch input and delay circuit may be immediately
seen.
The servo bar graph display is always operating
in this mode. To activate the servo cycling func-
tion,
first
turn
on the airborne
system.
Press
the
E (ON) key to start the servo cycling mode,
and use the F (OFF) key to stop the cycling.
When using the Bar Graph display to set up a
model or mix, be sure to verify that all controls
move the proper directions when actuated. De-
pending on servo orientation, it is possible that the
bar graph may indicate what appears to be the
correct directions of throw when one or more
servos actually need reversing.
Use the END key N to leave this function
and return to the System Menu.
Check Servos By Cycling
Check Functions and Mixing
Turn Servo Test On & Off With These Keys
System Section, Page 28
Bar Graph Display
Return to
System Menu
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 9ZHP_part1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 9ZHP_part1 in the language / languages: English as an attachment in your email.

The manual is 3,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info