29047
28
Zoom out
Zoom in
Previous page
1/78
Next page
System Section
VLT—BATTERY VOLTAGE DISPLAY
This function may be used to check the voltage
of both the
transmitter and
receiver
batteries
with
a high-accuracy digital voltmeter, which continu-
ously displays the measured results. The table
below indicates the measurement range of the
voltmeter.
The receiver battery may be tested with either
no load, or a load of 250 or 500 mA current flow.
Testing of the receiver battery requires a DSC cord
(the transmitter is always connected internally).
Be sure that the polarity of the receiver battery is
correct, or damage to the transmitter may result.
An alarm in the PCM 1024Z transmitter will go
off when the transmitter battery voltage becomes
too low. If you happen to be flying when this
alarm goes off, be sure to land as soon as possible
before control is lost.
Voltage Display
Item
No Load
Load (Choose)
Voltage Range
0-18V
3-
7V
Remarks
OFF
Approx. 250 or 500 mA
Transmitter Battery
Voltage Display
Receiver Battery
Voltage Display
Load Current
Setting
Return to System
Menu
• Receiver Load
Current Selection
To
switch loads on the receiver battery:
1. For no load, press the 0 (
OFF
) key
2. For the 250 mA load, press the J ( 250 ) key
3. For the 500 mA load, press the
K
(
500
) key.
4. To leave the voltmeter function, press the
N ( END )
key.
Note: if you do not activate the second timer, the volt-
meter display appears on the regular screen.
System Section, Page 26
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 9ZAP_part1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 9ZAP_part1 in the language / languages: English as an attachment in your email.

The manual is 3,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info