482734
16
Zoom out
Zoom in
Previous page
1/93
Next page
15
According to the description of the battery to be used and its
exclusive charger, please use it after carrying out full charge.
We recommend charging the batteries with the charger
supplied with your system. Note that the use of a fast charger
may damage the batteries by overheating and dramatically
reduce their lifetime.
When HT5F1700B is chosen, HBC-3A (4) is recommended.
When charging FT2F2100B, Please make sure to remove the
battery from the system to charge it. Charger for this battery
is recommended to use LBC-4E5.
CHARGING THE BATTERIES (When the rechargeable battery option is used)
Charging Your System’s Batteries
1. Connect the transmitter charging jack and batteries to the transmitter and receiver connectors of the
charger.
2. Plug the charger into a wall socket.
3. Check that the charger LED lights.
Charger
TX: Transmitter charging indicator
RX: Receiver charging indicator
To transmitter charging jack
Receiver battery
Battery Care and Precautions

and/or receiver battery packs. These are included to serve only as general guidelines, and are not intended
to replace or supersede the information provided by the battery and/or charger manufacturer. For complete
information, please refer to the instructions that are included with the battery pack(s) and/or chargers that
accompany the products purchased.
Do not allow children to charge battery packs without adult supervision.
Do not charge battery packs that have been damaged in any way. We strongly suggest frequent inspection
of the battery packs to ensure that no damage has occurred.
Do not to allow batteries to overheat! If overheated, disconnect the battery from the charger immediately
and allow to cool.

Do not deep cycle NiMH batteries as permanent damage could result.
Never charge batteries on a surface that may become hot, or may be impacted by the heat.
Immediately end the charging procedure if either the batteries or charger itself become overly hot.
NiMH cells do not exhibit the “memory effect” like NiCd cells, so little cycling is needed. Store NiMH
packs with some voltage remaining on the cells (refer to battery supplier).
NiMH cells have a self-discharge rate of approximately 20-25% (compared to 15% for NiCd batteries). It is
important to recharge NiMH batteries immediately prior to use.
Never connect the battery in reverse. Reverse connection will cause the battery to overheat or will damage
the inside of the charger.
Do not add an additional charge after charging.
Never charge with a current exceeding the nominal capacity (lC) of the rechargeable battery.
If a battery is charged with a current exceeding 1C, the battery will overheat and deteriorate.
Do not connect two battery packs or more to one output terminal.
Avoid extremely cold and hot places and the direct sunlight when you charge batteries.
It is recommended to perform charging within the 10 ~ 30°C (50-85°F) range. Otherwise, it may cause
abnormal charging and overheat.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 8J at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 8J in the language / languages: English as an attachment in your email.

The manual is 2,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info