28997
6
Zoom out
Zoom in
Previous page
1/82
Next page
Always pay particular attention to the flying field'srules, as well as the presence and location of spectators, the
wind direction, and any obstacles on the field. Be very careful flying in areas near power lines, tall buildings, or
communication facilities as there may be radio interference in their vicinity.
If you must fly away from a club field, be sure there are no other modelers flying within a three-to-five-mile range ,oryoumay
lose control of your aircraft or cause someone else to lose control.
At the flying field
Before flying, be sure that the frequency you intend to fly with is not in use, and secure any frequency control
device (pin, tag, etc.) for that frequency before turning on your transmitter. It is never possible to fly two or more
models on the same frequency at the same time. Even though there are different types of modulation (AM, FM,
PCM), only one model may be flown on a single frequency at any one time.
To prevent possible damage to your radio gear, turn the power switches on and off in the proper sequence:
1. Pull throttle stick to idle position, or otherwise disarm your motor/engine.
2. Turn on the transmitter power and allow your transmitter to reach its home screen.
3. Confirm the proper model memory has been selected.
4. Fully extend the transmitter antenna.
5. Turn on your receiver power.
6. Test all controls. If a servo operates abnormally, donít attempt to fly until you determine the cause of the problem.
(For PCM systems only: Test to ensure that the FailSafe settings are correct by waiting at least 2 minutes after
adjusting and then turning the transmitter off and confirming the proper surface/throttle movements. Turn the
transmitter back on.)
7. Start your engine.
8. Complete a full range check (see p. 17).
9. After flying, bring your throttle stick to idle position, engage any kill switches or otherwise disarm your motor/engine.
10. Turn off receiver power.
11.Turn off transmitter power.
If you do not turn on your system in this order, you may damage your servos or control surfaces, flood your engine, or in the
case of electric-powered or gasoline-powered models, the engine may unexpectedly turn on and cause a severe injury.
While you are getting ready to fly, if you place your transmitter on the ground, be sure that the wind won't tip
it over. If it is knocked over, the throttle stick may be accidentally moved, causing the engine to speed up. Also,
damage to your transmitter may occur.
Before taxiing, be sure to extend the transmitter antenna to its full length.
Acollapsed antenna will reduce your flying range and cause a loss of control. It is a good idea to avoid pointing the transmitter
antenna directly at the model, since the signal is weakest in that direction.
Don't fly in the rain! Water or moisture may enter the transmitter through the antenna or stick openings and cause erratic
operation or loss of control. If you must fly in wet weather during a contest, be sure to cover your transmitter with a plastic
bag or waterproof barrier. Never fly if lightning is expected.
6
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 7CAP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 7CAP in the language / languages: English as an attachment in your email.

The manual is 2,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Futaba 7CAP

Futaba 7CAP User Manual - Dutch - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info