28989
10
Zoom out
Zoom in
Previous page
1/64
Next page
2. Set the student transmitter modulation mode to PPM. Collapse the student’s antenna, and
fully extend the instructor’s antenna. Remove the RF module from the transmitter held
by the student (if it is a module-type transmitter).
3. Plug one end of the trainer cord into each
transmitter, with power switched off. The trainer
jack is in the center of the rear face of the
transmitter. Do not force, the connector is keyed.
4. Turn on the instructor’s transmitter. DO NOT turn
on the student transmitter power. Move the controls
on the instructor’s transmitter, and verify each
control moves the proper direction. Now verify that
the student’s trims and control travels match the instructor’s by using the trainer button
and switching back and forth while leaving the control sticks and trims alone, then
moving the control sticks.
5. The instructor’s transmitter has normal control over the model unless the trainer button is
pushed, when the student’s has control. If control is lost, the instructor should release the
trainer button and resume controlling the model.
OTHER T6XAS/XHS ADJUSTMENTS
Adjustable length non-slip control sticks
You may change the length of the
control sticks to make your transmitter more
comfortable to hold and operate. To lengthen
or shorten your transmitter’s sticks, first unlock
the stick tip by holding locking piece B and turning stick tip A counterclockwise. Next,
move the locking piece B up or down (to lengthen or shorten). When the length feels
comfortable, lock the position by turning locking piece B counterclockwise.
Stick lever tension adjustment
You may adjust the stick tension of your
sticks to provide the “feel” that you like for
flying. To adjust your springs, you’ll have to
remove the rear case of the transmitter. Using a
screwdriver, remove the four screws that hold
the transmitter’s rear cover into position, and put them in a safe place. Gently ease off the
transmitter’s rear cover. You may wish to unplug the battery wire. Carefully rotate the rear
of the case you you have access to the rear of the sticks. Now you’ll see the view shown.
Using a small screwdriver, rotate the adjusting screw for each stick for the desired
spring tension. The tension increases when the adjusting screw is turned clockwise, and
– 5 –
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 6XA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 6XA in the language / languages: English as an attachment in your email.

The manual is 1,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Futaba 6XA

Futaba 6XA User Manual - Spanish - 55 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info