Flaperon +
v-tail mixing
(FPv)
This mixing function is used when both
V-tail
mixing and flaperon mixing are required.
To activate Flaperon +
V-tail mixing
:
1. Connect the left ruddervator servo to channel 2 (elevator) in the receiver and connect the right ruddervator servo to
channel 4 (rudder) in the receiver.
2. Connect the aileron servo in the right wing to channel 1 (aileron) in the receiver and connect the aileron servo in the left
wing to channel 6 (flaps) in the receiver.
3. Enter the programming mode and access the W.MIX menu using the MODE key.
4. Push the DATA INPUT lever until FPv is displayed on the screen. Check all the control throws to make certain there is no
binding at the extremes and that the throws are as desired. Adjust any linkages necessary to set the correct throws.
Note: Reversing either of the servos involved with any of the mixing functions will reverse that servo, and that servo only
not both servos involved in the mix. To reverse both servos, each must be reversed separately. This applies to
programmable mixing and wing mixing.
15
