522199
10
Zoom out
Zoom in
Previous page
1/20
Next page
4.3 ELECTRICAL
The motor is a permanent magnet style motor. There are two
leads, which connect to the autopilot pump driver junction
box (processor). As mentioned previously the direction of the
pumpset can be reversed by simply reversing the polarity of
these two leads.
To test the operation of the HRP pumpset, touch the two leads
from the motor to the supply voltage (12 VDC or 24 VDC) to jog
the motor in one direction and then reverse the leads to jog the
pumpset in the other direction. Use caution not to perform this
operation where any combustible fumes exist.
The motors used on the HRP05, HRP11, and HRP17 pump-
sets are ignition protected, built to conform to UL-1500 and
SAE-1171 standards.
5. PREPARATION and TESTING
5.1 HYDRAULIC FILLING and TESTING
When installing a pumpset it is recommended that the system
be ushed to ensure that the oil is clean and free of contamina-
tion through out the hydraulic steering system.
After the hydraulic and electrical connection have been made,
open all valves if installed, and allow sufcient time for the
pump and lines to ll with oil. Operate the pumpset and note
the HOH time. This time varies with the type of steering system
and autopilot used
5.2 TESTING
Set the autopilot to the manual mode and operate the pumpset
to determine if the port and starboard directions are correct.
If the rudder goes the opposite way, reverse the two electrical
leads to the motor.
Most new autopilot systems will perform this test during their
dockside set-up procedures.
p07
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno HRP05 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno HRP05 in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info