612626
19
Zoom out
Zoom in
Previous page
1/58
Next page
1-13
1.12 Receiving
You can select a receiving frequency by one of the following methods:
- Direct frequency entry, or
- Channel number entry
Adjusting RF gain
In normal use the [RF GAIN] control should be set for maximum. If the audio on the received
channel is unclear or interfered with other signals, adjust (usually reduce) the control to im-
prove clarity.
Clarifier adjustment
If reception is unclear, try to clarify the signal as follows. For manual entry of frequency, sim-
ply turn the [FREQ/CH] control for fine tuning.
1. Press the [CLARI/3] key. (If a frequency is selected by CH No., the cursor which was
located at the channel number, moves under the 10 Hz place and “CLAR” appears on the
display.)
2. Turn the [FREQ/CH] control to fine tune the receiver on the wanted frequency.
3. To terminate this operation, press the [CLARI/3] key again. The cursor returns to the chan-
nel number.
S-meter
During reception, the meter works as a Sensitivity Meter indicating the relative signal strength
coming into the receiver front end. While in transmission, it indicates output level at the trans-
ceiver.
02
4
6810
S
Figure 1-11 S-meter
Note: S-meter will not work with AGC off.
Monitoring traffic on intended transmit frequency
When a semi-duplex (two-frequency simplex) channel is selected, it is recommended to moni-
tor it if there is no existing traffic on the frequency you are going to use. To do this, press the
[RX] key followed by the [ENT] key. The transceiver unit monitors traffic on the selected
frequency for three sec. If you want to monitor continuously, press the [TX] key followed by
the [ENT] key.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno FS-1503 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno FS-1503 in the language / languages: English as an attachment in your email.

The manual is 0,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info