689492
46
Zoom out
Zoom in
Previous page
1/75
Next page
4-14
Figure 4-15 How to wire and solder the autopilot cable
8. Reattach the display unit cover.
9. Referring to the Operator's Manual, conduct the self test. Confirm program
number. If the program number is younger than the number recorded on the
floppy disk (supplied), the program should be updated. If updating is not re-
quired this concludes the installation of the RP-17.
10.Connect a PC to the display unit as shown below. (Remove rubber cap under
front panel and connect XH4P connector.)
Figure 4-16 Connection of PC to display unit
11.Insert program update floppy disk in drive of the PC. Execute file (FR1500.bat)
for version update. TARGET POWER ON appears on the screen of the PC.
12.Turn on the radar. LOADER RX, MAIN PROG appear successively on the
screen of the PC. "Finish Version up. ted" appears on the screen of the PC
when the updating has been completed.("FINISH Ver up" appears on the ra-
dar display.) It takes from 5-6 minutes to complete the updating.
13.Disconnect the PC from the radar.
14.Press and hold down the GAIN control while pressing the [MENU] key five
times.
15.Press the [4] key, and then press the [ENTER/SELECT] key three times. This
clears previous program.
16.Turn the power off and on.
17.Press [MENU], [0], [0], [0], [0], [2], [2] to confirm program version of radar.
18.Turn on the switch S2 (AC set). Turn off the radar.
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno FR1525 MARK-3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno FR1525 MARK-3 in the language / languages: English as an attachment in your email.

The manual is 2,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno FR1525 MARK-3

Furuno FR1525 MARK-3 User Manual - English - 125 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info