689491
87
Zoom out
Zoom in
Previous page
1/125
Next page
-5.1-
5 MAINTENANCE
WARNING
Do not open the equipment
Hazardous voltage which can cause electrical shock exists inside the equipment.
Only qualified personnel should work inside the equipment.
Turn off the radar power switch before servicing the antenna unit. Post a
warning sign near the switch indicating it should not be turned on while the
antenna unit is being serviced.
Prevent the potential risk of being struck by the rotating antenna and exposure to
RF radiation hazard.
Wear a safety belt and hard hat when working on the antenna unit.
Severe injury or death can result if someone falls from the radar antenna mast.
Notice for technicians
The display unit designed to run on AC voltage has a
switch (S2) at its rear to cut off 115/230 V supply from
internal circuits. Turn off the switch when accessing
inside the display unit.
Switch S2
5.1 Periodic Maintenance Schedule
Periodic checks and maintenance are important for proper operation of any electronic systems.
This chapter contains maintenance instructions to be followed to obtain optimum performance and
the longest
possible life of the equipment.
Interval Check point Check and measures Remarks
3 to 6
months
Exposed nuts
and bolts on
antenna unit
Check for corroded or
loosened nuts and bolts. If
necessary, clean and repaint
them thickly. Replace them if
heavily corroded.
Sealing compound may be
used instead of paint. Apply a
small amount of grease
between nuts and bolts for
easy removal in future.
Antenna radiator Check for dirt and cracks on
radiator surface. Thick dirt
should be wiped off with a
soft cloth dampened with
fresh water. If a crack is
found, apply a slight amount
of sealing compound or
adhesive as a temporary
remedy, then call for repair.
Do not use plastic solvent
(acetone) for cleaning. If you
need to remove ice from
antenna unit, use a wooden
hammer or plastic head
hammer. Crack on the unit
may cause water ingress,
causing serious damages to
internal circuits.
87


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Furuno FR1510 MARK-3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Furuno FR1510 MARK-3 in the language / languages: English as an attachment in your email.

The manual is 1,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Furuno FR1510 MARK-3

Furuno FR1510 MARK-3 Installation Guide - English - 75 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info